Yamaha YRS-2000 Manual De Instrucciones página 72

Adjusting the system parameters
Parameter to be changed and front panel display
MEMORY PROTECT
You can protect the settings you saved in the system memory of this unit from being
accidentally erased or unwantedly changed.
MAX VOLUME
You can set the maximum volume level so that this unit will not output sound beyond the
limited volume level.
TURN ON VOLUME
You can set the initial volume level when the power of this unit is turned on.
DEMO MODE
You can test the sound beam output from this unit to experience the sound beam.
PANEL INP. KEY
You can disable the INPUT on the front panel when you adjust the system parameters.
F.PANEL KEY
You can disable the front panel keys except when you adjust the system parameters.
To enable the front panel keys,
turn off the power to the unit by
pressing STANDBY/ON on the
remote control, then follow the
steps to set the parameter to "ON
FACTORY PRESET
You can reset all of the parameters of this unit to the factory presets. This procedure
completely resets ALL the parameters in SET MENU.
Note
After performing the following
AUTO
procedure you must run
SETUP
again to match your surround
sound environment.
7
Press STANDBY/ON on the remote control to
set this unit to the standby mode.
STANDBY/ON
The new setting will be activated when you turn on the
power of this unit next time.
70
En
.
"
To change the system parameter settings, first turn off the
power to the unit, then follow the procedure to adjust the
system parameters.
y
When the demo mode is turned on, restart the unit, then press
ENTER while playing back sources to test the sound beam.
The sound beam being output shuttles between left and right.
Press ENTER again to stop shuttling.
Parameter settings
ON, OFF
MAX, 99 to 01, MIN
Control step: 1
MAX, 99 to 01, OFF
Control step: 1
ON, OFF
ON, OFF
ON, OFF
RESET, CANCEL