Switching The Flash Unit On And Off; The Selection Menu - Metz mecablitz 52 AF-1 Manual De Instrucciones

3.3 Switching the flash unit on and off

• Switch on the flash unit with the
The start screen appears.
The flash unit always switches on after-
wards with the mode of operation that was
used last (e.g. manual flash mode M).
52AF-1
The
mode. To switch off the flash unit, press
SON
the
+
If the flash unit will not be used for an
extended period of time, we recommend that
you switch off the flash unit with the
button and remove the power source
(disposable/rechargeable batteries).

3.4 The selection menu

• Press the
for the selection menu to appear.
k
The selection menu is divided into 4 sensor
buttons:
The modes of operation can be set after
pressing the
TTL, see 7.1
TTL HSS* , see 7.2
M, see 7.3
M HSS, see 7.4
MASTER, see 10.1
SLAVE, see 10.2
SERVO, see 10.4
*) only after data exchange with a camera.
146
D
button flashes red in stand-by
button until all displays turn off.
D
button as often as it takes
MODE
button.
button.
The flash parameters can be set after
PARA
pressing the button.
EV (exposure correction),
see 10.1.2.1, 10.1.3.1
Zoom (reflector setting), see 9.1
F ( aperture)
ISO (light sensitivity),
P (partial light output),
see 7.3 und 10.1.2.1
RATIO2) (lighting conditions), see 10.1.2.2
3)
CHANNEL ( Channel), see 10.2.3
2)
CTRL (Remote), see 10.1
3)
GROUP (slave group), see 10.2.3
2) only in MASTER mode.
3) only in SLAVE mode.
The touch display can be configured after
SERVICE
pressing the button, or the flash unit
can be reset to the factory setting.
CONTRAST see 14.1
BRIGHTNESS see 14.2
ROTATION (rotate the screen display),
see 14.3
RESET, see 15.3