Attaching An Interface Card - Sony BRU-300 Manual De Referencia Rápida

K VISCA RS-232C IN connector
Connect to the RM-BR300 Remote Control Unit
(not supplied). When you connect multiple
cameras, connect it to the VISCA RS-232C OUT
connector of the previous camera in the daisy chain
connection.
L VISCA RS-232C OUT connector
When you connect multiple cameras, connect it to
the VISCA RS-232C IN connector of the next
camera in the daisy chain connection.
M CAMERA connector
Connect to the optical connector of the BRBK-303
Optical Multiplex Card installed in the BRC-300/
300P camera using the CCFC-M100 Optical Fiber
Cable.
A dustproof cap is attached at the factory.
6
GB

Attaching an Interface Card

Attaching an Interface
Card
Attach an interface card such as BRBK-301 or BRBK-
302 (not supplied) to the card slot on the rear of this unit.
1
Loosen the two screws to remove the card slot
cover.
2
Insert an optional interface card into the card slot.
Align both ends of the interface card with the
sliders inside the slot, then insert the card securely
as far as it will go.
Interface card (not supplied)
3
Tighten the two screws on the interface card.
To remove the interface card
Loosen the two screws on the interface card and pull the
card out straight and slowly.
Note
Install different interface cards in each of two interface
card slots. If you install the same interface card in both
slots, the power indicator flashes red and the unit does
not operate.