Tabla de contenido
Idiomas disponibles
Idiomas disponibles
English
INSTALLING BATTERY FOR LASER GUIDE (Fig. C-1)
1.
Open the cover (1) of battery compartment by sliding
cover towards switch.
2.
Install 2 pieces of 1.5V batteries into the battery
compartment according to the polarity indicated on
compartment.
3.
Close the cover
4.
Turn on the switch (3) to check the LASER GUIDE
OPERATION.
NOTE: Replace the batteries with batteries that have a
reating of 1.5 volts (Number 4 sereis and AAA size or
equivalent). When replacing the batteries, the laser guide
should be thoroughly cleansed. Use a soft paintbrush or
similar device, to remove all sawdust and debris.
Fig. C-1
INSTALLING THE HEAD (Fig. D)
WARNING
The Drill Press head is very heavy and MUST be lifted witht
he help of 2 PEOPLE OR MORE to safely assemble the Drill
Press head on the column.
1.
Carefully lift the head (1) above the column (2) and slide
it onto the column. Make sure the head slides down over
the column as far as possible. Align the head with the
base.
2.
Using the hex wrench, tighten the two head lock set
screws (3).
Fig. D
INSTALLING FEED HANDLES (Fig. E)
1.
Locate the three feed handles in the loose parts bag.
2.
Screw the feed handles (1) into the threaded holes (2) in
the hub (3). Tighten.
3
1
2
1
3
2
– 12 –
Fig. E
2
3
1
INSTALLING THE CHUCK (Fig. F and G)
WARNING
Before any assembly of the chuck and arbor to the drill press
head, clean all mating surfaces with a non-petroleum based
product; such as alcohol or lacquer thinner. Any oil or grease
used in the packing of these parts must be removed,
otherwise the chuck may come loose during operation.
1.
Open the jaws of the chuck (1) by rotating the chuck
sleeve clockwise. To prevent damage, make sure the
jaws are completely receded into the chuck.
Fig. F
2.
Push the chuck (1) onto the spindle (2).
NOTE: Clean the spindle taper with a non-alcohol based
cleaner before inserting it into the chuck.
3.
Using a rubber mallet, plastic-tipped hammer, or a block
of wood and a hammer, firmly tap the chuck upward into
position on the spindle shaft.
Fig. G
2
1
Tabla de contenido
