To Connect The Backpack Battery To The Product; To Connect The Battery To The Product - Husqvarna 436LiB Manual Del Usuario

2. Put the battery in the battery charger.
3. Make sure that the green charging light on the
battery charger comes on. That means that the
battery is connected correctly to the battery charger.
4. When all LEDs on the battery come on, the battery is
fully charged.
5. To disconnect the battery charger from the mains
socket, pull the plug. Do not pull the cable.
6. Remove the battery from the battery charger.
Note: Refer to the battery and battery charger manuals
for more information.

To connect the battery to the product

WARNING: Only use Husqvarna original
batteries in the product.
1. Make sure that the battery is fully charged.
10
2. Slide the battery into the battery holder of the
product. The battery must slide easily, if not, it is not
installed correctly.
3. Press the lower part of the battery and push it in as
far as it will go into the battery compartment. The
battery will lock into position when you hear a click.
4. Make sure that the latches snap in place correctly.
To connect the backpack battery to the
product
1. Connect the adapter cable from the product to the
backpack battery.
2. Fasten the battery cable in the attachments on the
harness.
3. When the back pack battery is used, carry the
backpack battery on the back.
519 - 002 - 30.05.2018