DeWalt DW735 Manual De Instrucciones página 12

English
Fig. S
18

WARNING: Keep your fingers away from the
cutterhead at all times. Use the tool provided to
handle the knives.
8. Use the T-wrench to remove the eight screws on the
knife clamp and set them in the small screws bin
the front panel of the planer (Fig. T).
Fig. T
9. Use the magnets on the top of the T-wrench to attract
the knife clamp and lift it off of the cutterhead. One of
the knives should now be exposed.
10. Use the magnet 20 on the top of the T-wrench (Fig. S)
to attract the knife. Avoid touching it with your fingers.
nOTE: Before installing the knife, ensure the cutterhead and
knife are free of debris, clean if needed.
Fig. U
If Only One Side of the Knife Is Worn
1. Rotate the knife around so that the sharp, unused edge
hangs over the end of the cutterhead where it will cut
the material. Be sure to set the oblong holes in the knife
over the pins machined on the cutterhead.
2. Reset the knife clamp over the knife. Be sure to align the
beveled edge on the clamp with the sharp, cutting edge
of the knife. If these are not aligned correctly, the clamp
will not secure the knife properly.
3. Install the screws into the clamp and tighten sufficiently.
nOTE: Make sure all screws are tightened sufficiently.
10
To Access the Other Two Knives
1. Depress the cutterhead lock lever
Figure S.
2. Use the piece of scrap wood to carefully turn the
cutterhead until it locks into place revealing another
knife clamp.
3. Follow the same knife change procedure
indicated above.
4. Repeat the procedure for the last dull knife.
After Installing New Knives
1. Insert the round end of the dust shroud into the fan
housing and rotate it down to lock it into place.
2. Place the three wing nuts back into the shroud.
3. Screw the top cover of the planer back onto the unit.
on
19
nOTE: The planer will not operate if the top cover is not
placed correctly.
Brush Change (Fig. V, W)
Your planer is equipped with brush caps
external to the motor. If your brushes need to be replaced,
begin by acquiring a new set from a D
19
or a dealer authorized to service D
identical D WALT brushes.
e
Fig. V
To Replace the Brushes on your Planer
(Fig. V, W)
20
1. Use the T-wrench to remove the top cover and brush
cover screen on the planer.
2. Use a flathead screwdriver to unscrew the brush cap
located in the right, rear of the unit
Fig. W
22
3. Do the same for the brush cap located on the side of the
motor, inside the planer cover.
4. Place the new brushes into the brush holders.
18 as shown in
21 that are
WALT service center
e
WALT products. Use only
e
21
22 .