Vermeiren V300 DL Manual De Instrucciones página 22

Change the seat height according the following steps:
1.
Remove the rear wheels (see § 2.17).
2. Screw the axle bushings of the rear wheels from the axle plate.
3. Assemble the axle bushings in the right hole of the axle plate, see Table 2 and
previous figure.
4. Check if the axle bushings are fastened well.
Screw the swivel axles Ⓐ of the front wheels loose.
5.
6. Place the front wheels in the right hole of the front fork (table 2).
7. Place the bushings according table 2.
Install the swivel axles Ⓐ of the front wheels and tighten them. Check the tension in
8.
the swivel axle Ⓐ so it turn smoothly, but there is no space for motion.
9. Mount the rear wheels.
10. If installed properly the swivel axles of the front wheels and the ground must be
perpendicular. Check this.
11.
Adjust the brakes according § 3.5.
For other seat angle and seat height combinations, the above procedure can be used to
adjust the front fork and axle plate in the right combination.
If you do not find the right combination you can always contact the company Vermeiren.
Check that the swivel axles are perpendicular to the ground. If necessary use the procedure
below to adjust the castor stem housing:
1. Loosen the 3 bolts using a size 5 Allen key.
2. Adjust the castor stem housing to the desired angle.
3. Tighten the 3 bolts.
Castor
stem
housing
Bolts
Page 20
V300DL
2016-03
Indication 5 angle
positions (triangle)