Pioneer VSX-832 Manual De Instrucciones página 47

> Before Start > Part Names
Speaker Impedance Set the impedance (≠) of the connected speakers.
"4ohms": When any of the connected speakers have 4 ≠ or
more to less than 6 ≠ impedance
"6ohms (default value)": When the connected speakers all have
6 ≠ or more impedance
0 For impedance, check the indications on the back of the
speakers or their instruction manual.
∫ Crossover
Front Set the low range capabilities for each channel by setting either
small or large.
"Small (default value)": For small speakers whose low range
capabilities may be limited
"Large": For full-range speakers with sufficient low range
capabilities
If "Configuration" - "Subwoofer" is set to "No", "Front" will be
fixed to "Large" and the bass range of the other channels will be
output from the front speakers. Refer to the instruction manual of
your speakers to make the setting.
Center Set the low range capabilities for each channel by setting either
small or large.
"Small (default value)": For small speakers whose low range
capabilities may be limited
"Large": For full-range speakers with sufficient low range
capabilities
0 When "Front" is set to "Small", this is set to "Small".
0 If an item cannot be selected even though connection is
correct, check that the settings in "Configuration" - "Speaker
Channels" matches the number of connected channels.
> Install > Initial Setup > Playback
Advanced Setup
Height Set the low range capabilities for each channel by setting either
small or large.
"Small (default value)": For small speakers whose low range
capabilities may be limited
"Large": For full-range speakers with sufficient low range
capabilities
0 When "Front" is set to "Small", this is set to "Small".
0 If an item cannot be selected even though connection is
correct, check that the settings in "Configuration" - "Speaker
Channels" matches the number of connected channels.
Surround Set the low range capabilities for each channel by setting either
small or large.
"Small (default value)": For small speakers whose low range
capabilities may be limited
"Large": For full-range speakers with sufficient low range
capabilities
0 When "Front" is set to "Small", this is set to "Small".
0 If an item cannot be selected even though connection is
correct, check that the settings in "Configuration" - "Speaker
Channels" matches the number of connected channels.
Crossover When there are speakers that have been set to "Small", set the
Hz under which you would like other speakers to play bass, and
also set Hz under which you would like the LFE (low frequency
effect) to play the bass.
The value from "50Hz" to "200Hz" can be set. (Default Value is
"80Hz")
Double Bass This can be selected when the "Configuration" - "Subwoofer"
setting is "Yes" and the "Front" setting is "Large".
Boost bass output by sending the bass of the front speakers and
center speaker to the subwoofer.
"On": Bass output will be boosted.
"Off": Bass output will not be boosted.
0 The setting will not automatically be configured even if you
performed Full Auto MCACC.
∫ Distance
Set the distance from each speaker to the listening position.
| Supplementary Information | Others
47
En