Kenwood KSC-PSW8 Manual De Instrucciones página 6

Installation
Before fi xing the speaker in its position, be sure to check the sound while it is connected preliminary.
Caution:
• When making a hole under a seat, inside the trunk, or somewhere else in the vehicle, check that there is nothing hazardous
on the opposite side such as a gasoline tank, brake pipe; or wiring harness, and be careful not to cause scratches or other
damage.
• Install in a location that does not come in the way of driving, getting in or out of the vehicle and movement inside the
vehicle compartment.
• Fix the product fi rmly so that it will not be moved by vibrations or impacts during driving.
Fixing the cord in place
⑧ Tapping screw x 2
⑤ Fixture B
② 10-pin connector cord
Fixing the subwoofer
❶ Remove 4 screws (marked
of the speaker unit.
Removed screws can not be
reused.
❷ Attach the fi xtures A ④ to the speaker unit securely
using the machine screws ⑦. Be careful so that the
connected cords do not get in between the speaker
unit and fi xtures A ④.
❸ Drill the pilot holes for ø 3.6 mm (1/8") screws on
the sheet metal section of the vehicle , and attach
the speaker unit to the vehicle using the tapping
screws ⑥.
6
English
① Remote control
) at the bottom
Screw x 4
Remove
⑦ Machine screw x 4
④ Fixture A x 2
❶ Connect the 10-pin connector cord ② and remote
control ① to the speaker unit.
❷ Fix the cords to the speaker unit with fi xture B ⑤
and fi x in place with the tapping screws ⑧.
Prohibition!
⑥ Tapping screw x 4
Drill four pilot holes for
ø 3.6 mm (1/8") screws.
Fix the cord so that it will not protrude
from the side of the speaker unit.
④ Fixture A
Caution:
This portion becomes hotter
than other portions. Be careful.