Kenwood KSC-PSW8 Manual De Instrucciones página 4

Connections
Speaker input connection
Connect the subwoofer to the front speaker or rear speaker output cords of the audio components.
Notes:
• Read the instruction manuals for the connected components such as the audio components as well as this instruction
manual.
• In a computer-equipped vehicle, when you remove the
may occur in the electrical system of the vehicle. Consult your dealer for further details.
• When the audio components incorporates a DSP, do not connect to the rear output, as the low-frequency reproduction
eff ect may be attenuated due to the DSP eff ect.
Example
The following shows a typical connection for eff ective car stereo enjoyment. Connect your system by referring to the example.
Caution:
Do not distribute the cords in the paths
where they may be caught by a vehicle part
or damaged. Otherwise, an electric shock or
a fi re due to short-circuiting may result.
If there is no power control
terminal in the audio com-
ponents, connect the blue/
white wire to the accessory
line (ignition key switch
ACC position line).
Car fuse box
Ignition key
switch
Car fuse box
(Main fuse)
4
English
Audio components
Fuse 10A
Blue/White
If buzzing noise is heard from the speakers when the engine
is running, attach a line noise fi lter (commercially available) to
the power lead.
Yellow
Black
※
GND
※ Connect the black lead wire ground terminal directly with a
Battery
terminal of the battery, the memory may disappear, or a defect
⊖
Gray/Black Gray White
White/
SP.R
INPUT Black
SP.L
INPUT
Do not bend the vinyl-coated section
of the speaker cord. Otherwise, mal-
function may result.
③ Speaker cord
Yellow
Caution:
screw to an unpainted metal part of the vehicle. Turning the
power ON without connecting this terminal is linked to dam-
age of the stereo system. Be sure to connect it.
Also, painted metal panels etc., are not grounded and will
not function correctly. Be careful.
Front or rear speaker
Left
KSC-PSW8
② 10-pin connector cord
LINE IN
Right