Tabla de contenido
B-8 MIXER
1. Mounting
- Place the bowl support at the lowest side of the guides.
- Insert the bowl positioning it over the support and tightening the nuts.
- In this position, the tool required is engaged (hook, beater or balloon
whisk) in the shaft. Peg is engaged in the tool notch by the bayonet
system.
2. Maintenance
- No lubrication required. Never moisten the accessory with water.
- Check for the perfect cleanliness of the tool-holder shaft.
- Apply regularly a little oil to the two guides, the screws and the nuts.
Planetary shaft
Knurled nut
Tool
CR-140 VEGETABLE CUTTER AND GRATER
1. Fittings rack
Discs and grids are kept separate boxes, which can be coupled,
making a single hanging block.
In this rack, the fittings are protected against shocks and it's very prac-
tical.
The use of the rack leaves out any risk of accidents.
2. Installation of fittings
- Open the frame cover, by releasing the lock.
Ejecting
disc
FCE-2
FCE-4
FC-1
FC-2
FC-3
FC-6
FC-8
FC-10
FC-14
FCO-2
FCO-3
FCO-6
FF-6
FF-8
FF-10
- Install the ejecting disc on the driving shaft.
- If necessary, insert a grid in the inlet recess.
- Install a disc on the driving shaft.
- Lower the frame cover, and lock it.
Warning: It would never be allowed to insert the fingers in the cutter
accessory mouth when it is running. Always use only the lever.
Disc
Bowl guide
P-130 POTATO RICER / MASHER
1. Mounting
Bowl support
- Slightly tighten the two positioning nuts of the crown.
Friction of the propeller against the screen might originate a colour
Screw
change in the screened food. This friction comes from an excessive
tightening of the crown lock or from a screen deflection. If the screen
Bowl
is found curved, reverse its positioning on the device.
2. Maintenance
- Before the device is again reassembled, lubricate the shafts with
table oil.
HM-70 MEAT MINCER
1. Mounting
- Lock the device slightly tightening the nut. Locking must not be exc-
cesive.
2. Maintenance
- Before the device is again reassembled, lubricate the shafts with
table oil.
Discs
rack
FR-1
FR-2
FR-3
FR-4
FR-7
FR-8
FCC-2
FCC-3
FCC-5
CLEANING OF THE ACCESSORIES
-All the elements that are in contact with the product, should be clea-
ned immediately after use with hot water and a food compatible deter-
FM-8
gent.
FM-10
FM-20
-Clear copiously with hot water and desinfect with a soft cloth impreg-
nated with 90º ethyl alcohol.
7
Grid
Ejecting disc
Frame cover Cover look
Lock
nut
Crown
lock
Punched screen
Tabla de contenido
