Adjustments - Surtek SB710 Manual De Usuario Y Garantía

• Attach the wing nut
and Hex. socket head
cap screw to table
with the wrench Hex.
• Place table insert
into the table center
hole.
• Place the star knob onto Tension Rod.
After installation adjust the table so that the
saw blade runs through the center of the table
insert's slot.
CENTERING THE TABLE
• Loosen the screws
holding the lower
table trunnion.
• Move table sideways
as required, until saw-
blade runs through
the center of insert.
SETTING THE TABLE SQUARE WITH THE SAW
BLADE
• The saw table can
tilted up to 45°. To tilt,
loosen the wing nut
of the table trunnion.
• Loosen the wing nut
on the trunnion and
adjust the table at
90°with the blade.
• Check the table with a square to make sure
the table Is 90° with the blade. If an adjust-
ment is necessary, loosen the screw and adjust
the pointer to 0°
To ensure sufficient
upright stability of the
machine it should be
bolted to floor, bench
or table, or mounted
on the work stand,
available as optional
accessory.
E N G L I S H •
For this purpose 4 - Ø 6.5 mm holes are pro-
vided in the machine's base plate.
DUST COLLECTION
If this band saw is operated indoors it is recom-
mended to have it connected to a dust collec-
tor. The suction connector, supplied with the
machine, has to fitted to the dust ejection port
of the saw for this purpose. The diameter of
the suction connector is 60 mm.
CAUTION: Wood dust and chips, together
with an ignition source and the oxygen in the
ambient air, can cause fires and explosions,
injuries and allergies.
• Workmen working in operations processing
oak or beech timber where found to develop
more often cancer of the mucous membrane
of the nose (adenocarciome of the inner nose)
then other workers.
• Experience shows that skin contact with oak
or beech dust does not cause cancer.

ADJUSTMENTS

BAND SAW SETTINGS
CHANGING AND SETTING THE BLADE
This band saw is fac-
tory-equipped with
a general purpose
wood cutting blade
set. To change the
blade, remove the
wing nut and screw
from the table.
Then slacken the blade tension by turning the
hand wheel on top of the upper wheel hous-
ing.
Fit new blade and tension lightly. The blade
should run in the center of the rubber lined
band saw wheels or else it may jump of. To
check tracking, turn upper wheel by hand. If
required, adjust tracking with the knurled
handle at the rear of the upper wheel housing.
BLADE GUIDING
U se r ' s m an ua l
11