Tabla de contenido
Idiomas disponibles
Idiomas disponibles
4.1 Basic Operation Procedures
4.1.1 Dangers
Some parts of the machine electrical commands have high voltage
points or terminals . These when touched , may produce severe electric shocks , and
even DEATH .
Never touch a manual command ( button , electric switch, etc ) with wet
hands , shoes or clothes. If this warning is not followed electric shocks and even
DEATH , may occur .
4.1.2 Warnings
The Switch ON/OFF position must be well known , to allow to be used
without to look for it .
Before to proceed to any maintenance , unplug the machine from the
electric network .
Provide enough space around the machine to avoid falls .
Water and oil may produce a dangerous and slippery floor . To avoid
accidents the floor shall be dry and clean .
Never use a manual command ( button , switch , lever , etc ) unadvisedly .
If any work has to be done by more than one person , coordination signs
shall be accorded , for each step of the work . Next step shall not be started without the sign
is given and acknowledged .
4.1.3 Advices
Be sure this Manual INSTRUCTION has been fully understood . Each
function or operation procedure has to be perfectly clear .
Any manual command ( button , pulses , electric switch , lever, etc ) shall be
given only after to be sure it is the correct command .
If an electric supply failure happens , the machine shall immediately be
switched OFF .
Avoid any strikes on the machine , since they could produce failures or a
bad performance .
Avoid water, dust or dirt to
components of the machine .
DO NOT CHANGE the machine original characteristics .
DO NOT TEAR, WITHDRAW OR GET DIRTY , ANY SAFETY OR
IDENTIFICATION LABEL . If a Label is lost or unreadable ask for a new one to your Dealer .
4.2 Cares before to start the Blender
Read carefully this INSTRUCTION before to start the machine . Be sure it has
been correctly understood . If any doubt arises contact the department Chief
4.2.1 Danger
Electric wires must have a perfect insulation, any damage may cause an electric
shock .
Before to use them be sure they are in good conditions .
06
get inside the electrical or mechanical
IMPORTANT
or the Dealer .
5.2 Diagrama Eléctrico
19
Tabla de contenido
