Frequency Or % Duty Cycle Measurements; Temperature Measurements - Sonel CMM-10 Manual De Uso

In order to realise capacitance measurement it is necessary to
realise the following actions:

Set the rotary function switch to the Ω

Insert the black test lead banana plug into the negative COM
jack. Insert the red test lead banana plug into the positive
VΩTEMPHz%mAμA jack,

Press the MODE button to indicate "nF",

Touch the test leads to the capacitor to be tested

Read the capacitance value in the display.
6.9 Frequency or % duty cycle measure-
ments
In order to realise frequency or % duty cycle measurement it is
necessary to realise the following actions:

Set the rotary function switch to the Hz/% position,

Insert the black test lead banana plug into the negative COM
jack. Insert the red test lead banana plug into the positive
VΩTEMPHz%mAμA jack,

Touch the test probe tips to the circuit under test

Read the frequency on the display,

Press the MODE button to indicate "%",

Read the % duty cycle in the display.

6.10 Temperature measurements

In order to realise temperature measurement it is necessary to
realise the following actions:

Set the function switch to the Temp position,

Insert the temperature probe into the input jacks COM and
VΩTEMPHz%mAμA, making sure to observe the correct
polarity,

Touch the Temperature Probe head to the part whose temper-
ature you wish to measure. Keep the probe touching the part
under test until the reading stabilizes (about 30 seconds),

Read the temperature in the display,
CMM-10 – USER MANUAL
CAP position,
,
,
47