DeWalt DW831 Manual De Instrucciones página 15

discs. Before reconnecting the tool, depress and release the rear part
of the switch to ensure that the tool is off.
FITTING GUARD
CAUTION: Do not operate grinder with a loose guard or the
guard latch in the open position.
1. Open the guard latch (F) and align the arrow on the guard with the
arrow on the gear case.
2. Push the guard down until the guard lugs engage and rotate freely
in the groove on the gear case.
3. With the guard latch open, rotate the guard into the working
position providing maximum protection to the user (Fig. 7).
4. Close the guard latch to secure guard on gear case (Fig. 7).
NOTE: The guard is pre-adjusted to the diameter of the spindle hub at
the factory. If the guard needs further adjustment after a period of use,
perform the following ad just ment. With the guard latch in the closed
position tighten or loos en the adjustment screw (G).
REMOVING GUARD
1. Open the guard latch (F) and align the arrow on the guard with the
arrow on the gear case.
2. Pull the guard up until the guard lugs engage and rotate freely in
the groove on the gear case.
3. With the guard latch open, rotate the guard until the arrows are
aligned. (Fig. 7).
4. Remove the guard.
CAUTION: Do not tighten adjusting screw with guard latch in open
position. Undetectable damage to the guard or the mounting hub
may result.
FIG. 6
F
Fitting and Removing the Guard (DW840)
(Fig. 8)
CAUTION: Unplug the tool before mounting or
removing the guard. Guards must be used with
all grinding wheels and sanding flap discs, wire
brushes and wire wheels. Before reconnecting
the tool, depress and release the rear part of the
switch to ensure that the tool is off.
FITTING GUARD
CAUTION: Do not operate grinder with a loose
guard or the guard latch in the open position.
1. Place the angle grinder on a table, spindle up.
2. Press the guard down.
3. Position the guard between your body and the work piece.
4. Tighten the screw holding the cinch collar firmly around the neck
of the spindle.
REMOVING GUARD
1. Loosen the screw holding the cinch collar around the neck of the
spindle.
2. Lift up on the guard.
13
FIG. 7
G
FIG. 8