Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Installation and Connections
How to Install
A speaker's playback sound is delicately influenced by
conditions in the listening room. To produce optimum listening
conditions, take due consideration of the conditions of your
installation location before beginning actual installation.
Place the speakers at ear level.
The left and right speakers should be placed at an equal
distance from and bilaterally symmetrical to the listening
position.
Angling Speakers
You may use the rubber legs and cushions supplied as the situation demands with the unit to tilt the speaker surface upward or place
it vertically.
When using a speaker stand etc. to place the speaker surface vertically
Attach the supplied rubber legs (thicker ones) to the indents on the bottom surface.
When placing on a desk etc. with the speaker face tilted upward
Attach the supplied cushions (thinner ones) to the bottom of the unit in order to prevent slippage.
WARNING
Store small parts out of the reach of children and infants. If accidentally swallowed, contact a doctor immediately.
Connections
When making or changing connections, always turn off the
power and disconnect the power cord from its outlet.
Also, be sure to read the operating instructions for the other
components to which you are connecting these speakers.
8
En
Speakers should ideally be located at 30° angles from the
listening position (together forming a total 60° angle), and
rotated inward to face the listening position.
Do not block the heat sink section on the back. The resulting
reduction in heat radiation capabilities can lead to a
degradation in performance or cause malfunctions.
Do not plug in the power cord until all other connections have
been completed.
Use only the furnished accessory power cord.
• Make sure to set the sound level at an appropriate level as the
input signals to the XLR INPUT connector and RCA INPUT
jack will be mixed together, affecting the sound level.
60 °
D41-6-4_A1_En
Tabla de contenido
Solución de problemas
