Additional Information; Troubleshooting; Items To Check - Pioneer RM-05 Manual De Instrucciones

Additional Information

Troubleshooting

 If you think you are experiencing a malfunction with this unit, check the following items.Also check other devices connected to the
unit. If the problem persists, consult your dealer for service.
 On occasion, the unit may fail to operate properly due to static electricity or other external conditions. In this event, disconnect the
power cord and wait for five minutes or more, then reconnect the power cord and check for proper operation.
Symptom
No power
No sound from connected audio
devices, or sound is very small.
The POWER indicator (white) does not
come on.
Speakers do not resume (turn on) from
standby mode.
The sound distorts, or the indicator is lit
red.
Feedback (continuous howling sound)
Trademarks
 Pioneer is a registered trademark of PIONEER CORPORATION.
 Other listed company names and a product name are the registered trademark of the companies or trademarks.
10
En

Items to Check

Is power cord connected properly?
Has connected audio device been set properly?
Is connection cable connected properly?
Are connectors or plugs dirty?
Is the sound volume set properly?
Is the power turned on?
Is the auto standby function on?
Is the power turned on?
Is the auto standby function on?
Is the level of the input signal low?
Is the level of the input signal too high?
Is the output level of the connected audio device set
properly?
Is the sound volume set properly?
Remedy
Connect power cord to outlet.
Set device's external input and sound volume properly.
Connect cables properly.
Clean connectors and plugs before connecting.
Turn the [LEVEL] dial on the rear panel clockwise and
turn up the volume.
Turn on the [POWER] switch on the rear panel.
Turn off the [POWER] switch on the rear panel once,
wait a few seconds, and then turn it back on.
Turn on the [POWER] switch on the rear panel.
Turn off the [POWER] switch on the rear panel once,
wait a few seconds, and then turn it back on.
Increase the level of the input signal.
Turn off the [AUTO STANDBY] switch to turn off the
auto standby function.
Slowly turn the [LEVEL] dial on the rear panel
counterclockwise and turn down the volume.
Adjust the output level of the connected audio device
properly.
Slowly turn the [LEVEL] dial on the rear panel
counterclockwise and turn down the volume.