Preparation; Connecting The Power; Attaching The Cord - Tascam MZ-372 Manual Del Usuario

C (MONO) /MIC input jacks
h
These are analog XLR input jacks (1: GND, 2: HOT,
3: COLD).
Their input gains can be adjusted using the GAIN
( ) knobs on the front of the unit.
4
INPUT LEVEL switches
j
Use these to set the input levels of the input sourc-
es (mic or line) connected to the C (MONO) /MIC
( ) input jacks.
h
Set to MIC for mic level signals, and set to LINE for
line level signals.
LINE/PHONO input selection switches
k
For channels 2–4, if the output of a CD player or
similar device is connected to a LINE A input (
jack, set this to LINE. If a record player output is
connected, set it to PHONO.
Cord holder
l
Attach the power cord of the included AC adapt-
er (TASCAM PS-M1524) here to prevent accidental
disconnection. (See "Attaching the cord" on page
11.)
DC IN 15V connector
;
Connect the included AC adapter (TASCAM PS-
M1524) here.
MONITOR OUT jacks
z
These RCA pin jacks are analog monitoring out-
puts.

Preparation

Connecting the power

Use the included AC adapter (TASCAM PS-M1524) to
connect a power supply to the unit as shown below.
Power outlet
DC plug
CAUTION
Always use the AC adapter (TASCAM PS-M1524)
that was packaged with the unit. Using a different
AC adapter could cause malfunction, overheating,
fire or other problems.
TASCAM
PS-M1524 (included)
SUB OUTPUT jacks
x
These RCA pin jacks are analog outputs.
Mono signals will be output if the SUB OUTPUT
) switch is set to MONO.
(
d
MAIN OUTPUTS 1-2 (BALANCED) jacks
c
These analog outputs are XLR jacks. (1: GND, 2:
HOT, 3: COLD)
Use the ATTENUATOR (
output levels.
LINE A/B input jacks
v
These RCA pin jacks are analog line outputs.
Record players can be connected to the LINE A
input jacks of channels 2–4. When connecting
)
a record player to these jacks, also connect its
v
grounding wire to the | (GND) jack (
the LINE/PHONO input selection switch (
PHONO.
(GND) connectors
b |
If a record player is connected to the LINE A input
( ) jacks of channel 2–4, also connect its ground-
v
ing wire to this.
NOTE
If a humming noise occurs when connecting a
device other than a record player, connecting
a grounding wire from the metal frame of that
device (or the rack frame if rackmounted) to this
could reduce the noise.
NOTE
The AC adapter for the unit includes two types of
adapter cords. Attach the type of AC adapter cord
that matches the power outlet that you are using.

Attaching the cord

In order to prevent the cord from becoming discon-
nected during use, attach it to the cord holder (
when connecting it to the unit.
1.
Remove the cord holder (
2.
Place the cord in the cord holder (
3.
Tighten the cord holder (
) switches to change the
g
), and set
b
) to
k
l
) screw.
l
).
l
) screw.
l
11
TASCAM MZ-372
)