Check Fuel System; Check Spark Plug; Care For Cutting Blades - Shindaiwa DH202 Manual De Instrucciones

Maintenance and care

Check fuel system

1. Fuel tank cap

Check spark plug

a: 0.6 - 0.7 mm

Care for cutting blades

 Wear gloves to protect hands from sharp blades.
 Failure to observe these precautions could lead to injury.
1. Bolt slots
 Check before every use.
 After refuelling, make sure fuel does not leak or exude from
around fuel pipe, fuel grommet or fuel tank cap.
 In case of fuel leakage or exudation there is a danger of fire.
Stop using the machine immediately and request your dealer
to inspect or replace.
 Check plug gap. Correct gap is 0.6 mm to 0.7 mm.
 Inspect electrode for wear.
 Inspect insulator for oil or other deposits.
 Replace plug if needed and tighten to 15 N•m - 17 N•m (150
kgf•cm to 170 kgf•cm).
CAUTION
Lubricating blades (Every 4 hours of operation)
Apply a few drops of oil the each bolt slots at the bottom of
blades.
Cleaning blades (After each use)
Remove gummy residue from blades with a 50 : 50 mixture of
kerosene (paraffin) and machine oil.
20