SEVERIN KA 5953 Instrucciones De Uso página 9

replacement of the power cord. If repairs
are needed, please send the appliance to
one of our customer service departments.
The address can be found in the
appendix to this manual.
Operation
Multiple-function switch
The multiple-function switch has the
following settings:
Steam symbol: steam nozzle open,
heating element switched on.
Appliance is switched off.
0
Espresso symbol: hot water outlet
open, heating element switched on.
Indicator lights
The red indicator light is lit when the heating
element is switched on and brewing is in
progress.
Once brewing is finished, the red light goes
out and the green light comes on.
Before using for the first time
Before making espresso for the first time, let
the appliance go through two or three
filtration cycles using the indicated
maximum amount of water, but without
using any ground coffee. This should also be
done if the appliance has not been used for
an extended period of time.
Making espresso
- Open the screw-in lid by turning it anti-
clockwise.
- Fill the container with cold tap water.
The glass carafe shows arrow-shaped
level marks for two or four cups. Only
the required amount of water should be
used for each brewing cycle (max. 4
cups).
- Replace the lid and close it by turning it
clockwise.
- Place the filter insert inside the filter
holder.
- Use the measuring scoop to fill the filter
insert with the desired amount of
espresso coffee; fill loosely and do not
press it down. The corresponding
markings for the correct amount of
espresso coffee can be found inside the
filter insert.
Remove any excess coffee from the rim
of the filter holder.
- Fit the filter holder to the appliance in
such a way that the protruding lugs go
inside the corresponding recesses on the
hot water outlet. The arrow mark on the
filter holder must be correctly aligned
with the beginning of the corresponding
mark on the housing.
- To lock, turn the filter holder firmly to
the right so that the dot on the holder is
correctly aligned with the dot on the
housing.
- Slide the glass carafe with its lid in place
onto the drip tray under the filter holder.
●
Ensure that the lid opening is properly
positioned underneath the filter holder.
- Insert the plug into a suitable wall outlet
and turn the multiple-function switch so
that the espresso symbol is aligned with
the arrow mark on the housing. The red
indicator light comes on.
- After a short time the water will start to
boil and will then be forced by pressure
through the filter insert into the glass
carafe.
- Wait until all the water has passed
through. Only when the red indicator
light has been replaced by the green light
may the appli-ance be switched off.
- The carafe can now be removed from the
appliance.
To release the excess pressure from the
water container and thus depressurise the
appliance:
- Place a suitable container under the
steam nozzle
multiplefunction switch so that the steam
symbol is aligned with the arrow mark on
the housing, until steam is no longer
9
and turn the