Idiomas disponibles
Idiomas disponibles
Before you call for service...
Troubleshooting tips
Save time and money] Review the charts on the following
pages first and you may not need to call for service.
Possible Causes
What To Do
Dryer is unplugged
• Make sure tile duet plug is pushed completely into
tile outlet.
Fuse is blown/circuit
breaker is
• Check
tile house tnse/circuit
breaker
box and
tripped
replace
fllse or reset breaker.
NOTE: Most electric
(hyers use two filses/breakers.
Dryer doesn't heat
Fuse is blown/circuit
breaker
is
• Check
the house filse/drcuit
breaker
box and
tripped,
the dryer may tumble
replace
fllse or reset breaker.
but not heat
Gas service is off
• Make sure gas shutoffat
&yer and main shutoffare
fillly open.
Dryer shakes ormakes
Some shaking/noise
is normal.
• Move (hyer to an even floor space, or a(!just
noise
Dryer may be sitting unevenly
leveling
legs as necessa U until even.
Greasy spots on clothes
Improper
use of fabric softener
• Follow directions
on lid)tic softener
package.
Drying dirty items with clean ones
• Use your duet
to d U only clean items. Dirty items can
slain clean items and the &yer.
Clothes were not completely
clean
• Sometimes
st_fins which cannot
be seen when tile
(lothes
are wet appearafier
duiug.
Use proper
x_;tshing procedures
beti)re &ying.
lint on clothes
Lint filter is full
• Clean lint s(reen
betbre
each load.
Improper
sorting
• Sort lint producers
(like chenille)
from lint collectors
(like corduroy).
Static electricity
can attract lint
• See suggestions
in this section
under
STATIC.
Overloading
• Separate
large loads into smaller
ones.
Paper,
tissue, etc., left in pockets
• Empty all pockets
betore
laundering
clothes.
Static occurs
No fabric softener
was used
• T U a ihbric softener.
• Boun(e
_PFabric (_onditioner
D_yer Sheets have
been approved
fi)r use in all liE Ihyers
when used in
ac(ordance
with the manufacturer's
inslnactions.
Overdrying
• T D"a fhbric sofieuer.
• At!jllSl controls
ti)l" less (h)4ng.
Synthetics,
permanent
press
and
• TD_ a thbric
softener.
blends
can cause static
Inconsistent drying times
Type of heat
• Autom;ttic
dD_ing times xdll vmy accorcfing
to the type
of heat used (electric,
natural
or l A' gas), size of h)ad,
types of fabrics,
wemess
of clothes and condition
of
exhausl
ducls.
12
