Whirlpool AKZ9S 8220 NB Manual Del Propietário página 8

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 31
Before to run the descaling phase, the appliance
will check if some residual water is contained into
the boiler, and a Drain cycle could be performed,
if needed. In this case, you will have to empty the
drawer after the Drain cycle, before continuing with
the Descale Phase.
Please note: to ensure that the water is cold, it is not possible
to perform this activity before 30 minutes have elapsed from
the last cycle (or the last time the product was powered).
During this waiting time, the display will show the following
feedback "WATER IS HOT".
PHASE 1/2: DESCALING 70 MIN
When display will show <ADD 0.25 L OF SOLUTION>,
please pour the descaling solution in the drawer. For
best results in descaling, we recommend filling the
tank with a solution composed of 75 g of the specific
WPRO product and 250 ml of drinking water. Make
sure the solution dissolves completely in the water
so that no residue remains. WPRO descaler is the
suggested professional product for the maintenance
of the best performance of your steam function in the
oven. For orders and information contact the after
sales service or www.whirlpool.eu. Whirlpool will
not be held responsible for any damage caused by
the use of other cleaning products available on the
market.
1
250 ml
Once the descaling solution is poured inside the
drawer, press
to start the main descaling process.
The descaling phases do not need you to stay in front
of the appliance. After each phase is completed, an
acoustical feedback will be played and the display
will show instructions to proceed with the next
phase.
Once the descaling phase has been completed, the
boiler will be drained: the descaling solution used
during this phase will be poured into the extractable
drawer.
PHASE 2/2: RINSING (30 min.)
To remove descale residuals from the drawer and the
steam circuit, rinse cycle has to be done. When display
shows <ADD 0.25 L OF WATER> fill the tank with 0,25 L
of drinking water, then press
not turn off the oven until all the steps required by the
function have been completed.
When the message "DESCALING COMPLETED" appears
on the display, please press OK to confirm.
Cooking functions cannot be activated during the
cleaning cycle. Please note: A message will be shown
= 75 g
+
2
+
3
to start the rinsing. Do
on display, to remind you to execute this operation
regularly.
When Descale procedure is completed, it is suggested
to dry the cavity from potential water residuals. It will
be then possible to use all the steam functions.
Note: during the Descale cycle, some noise could
potentially be heard since the oven pumps are
activated in order to guarantee the optimal descale
efficiency.
Once the maintenance cycle has started, do not remove
the drawer unless requested by the appliance.
. MINUTEMINDER
When the oven is switched off, the display can be
used as a timer. To activate this function, make sure
that the oven is switched off and press
icon will flash on the display.
Press
or
to set the length of time you require and
then press
to activate the timer.
MINUTE-MINDER
An audible signal will sound and the display will
indicate once the minuteminder has finished
counting down the selected time.
Please note: The minuteminder does not activate any of the
cooking cycles. Press
or
timer.
Once the minuteminder has been activated, you can
also select and activate a function.
Press
to switch on the oven and then select the
function you require.
Once the function has started, the timer will continue
to count down independently without interfering
with the function itself.
Please note: During this phase, it isn't possible to see the
minuteminder (only the
continue counting down in background. To retrieve the
minuteminder screen press
currently active.
. KEYLOCK
To lock the keypad, press and hold
seconds. Do this again to unlock the keypad.
KEYLOCK
Please note: This function can also be activated during
cooking. For safety reasons, the oven can be switched o at
any time by pressing
or
to change the time set on the
icon will be displayed), that will
to stop the function that is
for at least five
.
: The
loading