cecotec ENERGYSILENCE AERO 5200 LIGHT WHITE Manual De Instrucciones página 47

7. Loosen the screws of the downrod bracket and then place the downrod (Fig. 10). Pass
the fan wires and the earth wire through the downrod. Align the holes in the clevis pin of
the downrod with the holes in the bracket. Make sure to insert the straight part of the pin
through the hole in the end of the clevis pin and press until the crimped part snaps into
position. Finally, retighten the screws.
NOTE
It is very important that the downrod bracket pin is correctly installed and that the screws are
tightened securely.
If the pin, clevis, or screws are not correctly positioned, the fan may fall down.
8. Lift the fan carefully and place the downrod and hanging ball in the mounting bracket
attached to the ceiling. Make sure that the groove in the hanging ball is properly aligned
with the tab on the mounting bracket. Fig. 11
Connections. Fig. 12
WARNING
To avoid the risk of electric shock, be sure to disconnect the mains supply from the
switchboard before connecting the cables.
9. Connect the main power supply (house) to the terminal block located on the mounting
bracket. Plug the receiver into the bracket with the flat side up.
- Insert the 3P connector of the mounting bracket into the AC POWER INPUT socket of the
receiver.
- Insert the 2P connector from the motor light into the 2P LIGHT socket on the receiver.
- Insert the 3P connector from the motor light into the 3P MOTOR socket on the receiver.
- Connect the yellow/green 1P connectors of the motor and the mounting bracket.
10. Carefully attach the LED light to the main frame and turn it clockwise to secure it. Fig. 13
Note: the lampshade shall be positioned at an oblique angle. Fig. 14
11. Fit the canopy by tightening the two screws. Fig. 15
4. OPERATION
Remote control
Fig. 16 key:
1. Power button
2. Winter Function
ENERGYSILENCE AERO 5200 LIGHT WHITE / BLACK
ENGLISH
47