Idiomas disponibles
Idiomas disponibles
ENGLISH
-
The mower will perform cutting cycles when fully charged until it detects a lack of battery
power.
-
The mower can begin in a second starting area, other than the charging station. If the
mower has the second starting area activated (ON), it will proceed to a second area from
which it will start after the first full discharge of the battery.
-
The mower changes the cutting direction when it detects an obstacle thanks to its shock
sensor located on the bumper, so this is common and normal in the mower's operation.
-
A number may appear momentarily on the display during the cutting task, this is due to the
remaining battery percentage of the mower.
Changing the PIN code
-
To change the PIN code, press and hold the
seconds. "PIN 1" will start flashing on the display, which means that you must enter the old
PIN. When "PIN 1" is displayed, the first number of the PIN will flash. Use the
buttons to select the number you wish, and press
number of your old PIN will flash. Repeat the process with the remaining numbers of your
old PIN. After that, you can enter a new PIN. In this example, the PIN we want to set is 1234.
When you have entered your old PIN, "PIN 2" will start flashing on the display and so will
the first number. Do the same to enter the new PIN code of your choice (in this example it
is 1234).
changed the PIN code.
-
You can change the PIN code from the App by pairing the mower and following the
instructions in the settings menu. If you do not remember the PIN code, try to access
the mower by following the pairing process and then change the PIN code. If after these
attempts you are unable to do so, please contact the official Cecotec Technical Support
Service.
Setting the mower's date
-
The year, month, day and time must be set, these are mandatory configuration items. If
you do not set these elements correctly, it will influence the programming schedule. These
elements must be set in the order: year, month, day, and time.
-
To start the configuration, press and hold
and/or
to select the year. Then press
continue with setting the month and day in the same way, e.g. 08.25 would be 25 August.
-
In the meantime, the year will be displayed and then a number to indicate the date, e.g.
08.25 (25 August). Fig. 11
-
The time will then be shown on the display, e.g. 13:25. When it flashes, use
select the desired number and press
complete,
126
CONGA GRASSHOPPER 500 CONNECTED
will then appear on the display, which means that you have successfully
will appear on the display. Fig. 11
and
buttons at the same time for 3
to confirm the setting. Then, the next
for 3 seconds. For example, 2020. Use
to confirm and finish the configuration. Next,
to confirm the setting. When the time setting is
or
or
to
