Idiomas disponibles
Idiomas disponibles
ENGLISH
2. The charging station should be placed on a relatively flat surface. Do not place it on an
inclined surface and avoid bending the robot's support surface.
3. We recommend that the power supply unit is placed on a wall at a minimum height of 30
cm. The power cable must be outside the working area of the mower.
4. Position the charging station as shown in figure 3, following the indications on the support
surface of the charging station, leaving the "IN" area as the area to be cut and "OUT" as the
outer area which will be outside the boundary wire and therefore excluded from the cut.
5. Once the charging station is in place, pass the beginning of the boundary wire through the
housing in the middle of the charging station to the red terminal at the rear of the charging
base.
6. Strip the end of the boundary wire about 10 mm to connect it so that it makes good contact
with the red terminal of the charging station. Fig. 4
7.
Once the first end is connected, you should continue with the installation of the boundary
wire.
Boundary wire installation
If you do not want the mower to pass through certain areas (because there are flowers, bushes,
or trees, for example), mark them off with the boundary wire. As shown in Fig. 5, the mower can
pass through areas with a minimum width of 0.8 m.
5. When laying the boundary wire, use the distance guide to leave a minimum distance of
35 mm between the wire and obstacles. Each peg should be placed at a distance of about
80 cm. Use the provided distance guide. If the ground is uneven, additional pegs must be
fitted to ensure that the wire is fully submerged in the ground. Fig. 6.
Note: if there are any obstacles within the cutting area such as sprinklers, make sure that they
do not exceed 1.5 cm in height so that they do not come into contact with the blades. In case the
obstacle has a longer length, please make sure to cover these areas with a height higher than
the height of the robot or delimit the area with the boundary wire.
1.
Ensure that the boundary wire is completely straight, dipped into the ground and that all
angles are at least 90°. Fig. 7
Note: the mower can climb slopes of up to 27% gradient (15°). Avoid letting the mower pass
through areas with a higher percentage of slope. Fig. 8
2. To see how to lay the boundary wire according to the slope of your terrain, see figure 8.
3. To close the cutting perimeter, cut off the excess wire and strip the end 10 mm to connect
it to the black terminal.
Connecting the charging station to the mains
Connect the boundary wire correctly and then, plug the power supply into the mains socket.
The green LED indicator light on the charging station will light up, indicating that the connection
has been made correctly and that the circuit with the boundary wire is properly connected.
124
CONGA GRASSHOPPER 500 CONNECTED
