cecotec CONGA GRASSHOPPER 800 CONNECTED Manual De Instrucciones página 125

LED indicator
lights
No indicator
light is on
Steady green
Flashing green
Flashing red
4. OPERATION
1. Once the installation process is completed, the mower will be ready for use.
2. Press the button until the mower switches on. The first time you do this, enter the
default PIN code (0000). To do so, press four times
in Fig. 9. (See section "Changing the PIN code" if you wish to change it).
Note:
- The mower will switch off after 30 seconds if no operation is performed.
- If an incorrect PIN is entered ten times, the mower will beep and then switch off. You can
try to enter the PIN again after 50 minutes.
- The robot needs the correct PIN to charge.
- While the robot is charging, it will stop emitting an electrical signal through the cable.
3. Press and then
4. Press and then
mower, remember to use the cutting knob to adjust the cutting height (the cutting distance
is in relation to the ground).
- The mower will mow the lawn without interruption until its battery level is low. It will then
return to the charging station. When fully charged, if it is within the operating time range,
it will automatically restart, or remain on the charging station if it is outside the operation
time range.
Meaning
The charging station is not
connected to the mains.
The boundary wire is
correctly connected.
The battery is fully
charged.
The mower is charging.
The boundary wire is not
connected or is damaged.
so that the mower starts operating.
for the mower to return to its charging station. Before starting the
Action required
Check that the power cable is properly
connected to the charging station, and
that the charging station is connected to a
suitable power supply.
This is normal, no action is required.
This is normal, no action is required.
Check that both ends of the boundary wire
are securely connected.
Check the boundary wire for damage.
until number 0 flashes, as shown
CONGA GRASSHOPPER 500 CONNECTED
ENGLISH
125