cecotec EnergySilence Aero 5200 Black Manual De Instrucciones página 49

7. Clevis pin
8. Locking screw
- If you want the fan to hang lower, you must remove the hanging ball from the supplied 6
inch downrod for use with a longer rod (included). If you want to use the 6-inch downrod
follow the steps below.
- To remove the hanging ball, loosen the suspension ball locking screw and remove the pin.
Lower the suspension ball. Slide the hanging ball off the downrod, and slide it onto the
longer downrod (note that the top of the rod has a hole for the locking screw). Insert the
stop pin into the top of the extended downrod and raise the hanging ball. Make sure the
clevis pin is aligned with the holes on the inside of the hanging ball and tighten the locking
screw securely.
Tip: to prepare for passing the electrical wires through the rod, attach a small piece of electrical
tape to the ends of the electrical wires to hold them together when passing them through the
rod. This will help them to pass without any problems.
Loosen the fixing screws and nut on the top of the motor housing. Remove the pin and
2.
clip from the lowering rod (if you have not already done so). Slide the downrod through
the canopy.
Pass the electrical wires through the rod and pull the wires protruding from the top end
3.
of the rod.
4. Place the downrod in the anchorage of the motor housing and insert the previously
removed pin. Tighten the fixing screws and the anchor nut securely. Lower the canopy
onto the motor housing
Connecting the remote-control receiver cables. Fig. 8
Canopy assembly. Fig. 9
Lift the canopy up to the mounting bracket, aligning the loosened screws in the bracket
5.
with the holes in the canopy. Turn the canopy to lock it. Re-insert the screws and secure
them all with a screwdriver.
Once you have secured the mounting bracket to the connection cover, you can hang the
6.
fan. Hold the fan firmly with both hands. Slide the downrod through the opening in the
mounting bracket and allow the ball to rest on the bracket. Rotate the hole in the hanging
ball until it aligns with the tab on the mounting bracket.
Tip: have someone else hold the ladder securely and bring the fan closer to you once it is on
the ladder.
Blade assembly. Fig. 10
Time saver: blade bolt washers can be installed on each blade prior to installation.
ENERGYSILENCE AERO 5200 BLACK | WHITE
ENGLISH
49