Idiomas disponibles
Idiomas disponibles
Flame check
Turn each burner on, and ensure that the flame is blue with minimal yellow
tipping. If there is significant yellow tipping, flame lift off or excessive noise,
check pressure and adjust at the regulator if necessary.
If satisfactory operation cannot be achieved, contact place of purchase or
their appointed agent for service.
Igniter operation
Check that the igniter for each burner successfully ignites the gas.
If an igniter fails to work, first remove the plug from the electrical power outlet,
and then check that all the electrical connections are in place.
If satisfactory operation cannot be achieved, contact place of purchase or
their appointed agent for service.
Low flame setting
Check the low flame setting for each hob burner to ensure that the minimum
flame will not be extinguished by air draughts.
• Light the burner.
• Turn the control until it engages in the minimum position.
• Ensure the flame is stable and will not be extinguished by air draughts.
To adjust the minimum flame:
Follow the procedure described in the gas conversion instruction.
DO NOT MODIFY THIS APPLIANCE IN ANY WAY, OTHER THAN AS
DESCRIBED IN THESE INSTRUCTIONS.
DATA PLATE
Electrical
see data plate
connections
This appliance conforms to the following
European Economic Community directives:
- 2006/95/EC dated 12/12/06 (Low Voltage)
and subsequent amendments
- 2004/108/EC dated 15/12/04
(Electromagnetic Compatibility) and
subsequent amendments
- 93/68/EEC dated 22/07/93 and subsequent
amendments.
- 2009/142/EC dated 30/11/06 (Gas) and
subsequent amendments
- 2012/19/EU and subsequent amendments.
EU Regulation no. 66/2014 implementing
ECODESIGN
Directive 2009/125/EC.
standard EN 30-2-1
Checking the operation
Ignite each burner and check the appearance of the flame, the flame should
be blue and burn smoothly on high & low.
Ensure complete igniton of all burners.
Where the data plate is obscured by cabinetry when the cooker is in the
installed position, place the supplied duplicate data plate to a suitable adjacent
surface or within the instruction manual for future reference.
For other minor adjustments or if the appliance does not perfrom correctly;
contact Arisit Pty Ltd 1300 762 219
AUS
9
