Idiomas disponibles
Idiomas disponibles
The machine body down to the lowest and press the
position limit rod switch (picture 8).
A - Rod switch
When the machine appears big sparks or doesn't rotate, if
the carbon brush is worn and less than 5 mm, it needs to
be replaced.
Please keep it clean and make it slides freely in holding
brush.
Please replace two brushes at the same time and use the
specified "355 cut" brand electric brush. Please use
screwdriver to screw the lid of the holding brush, take out
the wearing carbon brush and insert the new ones, and
then screw the lid of holding brush tightly (picture 9).
A - Screwdriver
B - Brush cap
Before assembling or disassembling the cutting wheel, do
confirm the machine is under switch off condition, and the
plug is drawn out.
The maximum circumferential velocity of the cutting wheel
shall not less than 4OOO m/min. The maximum diameter of
the cutting wheel shall not more than 355mm.
Do confirm the hexagonal bolt is screwed tightly, if it is not
screwed tightly enough, it is possible to cause.
The packaging is made up of recyclable materials,
which you can dispose on local recycling points.
Never dispose of power tools with your household
waste!
According to the European Directive 2012/19/EC on
electrical and electronic equipment waste and its
transposition into national law, power tools must be
collected separately and delivered to the collection sites
provided for this purpose.
You can get information regarding the disposal of the power
tool through the person in charge for recycling in your city.
WhatsApp:
+351 965 157 064
E-mail:
