Idiomas disponibles
Idiomas disponibles
Have your power tool serviced by a qualified repair person
using only identical replacement parts. This will ensure that
the safety of the power tool is maintained.
Hold power tool by insulated gripping surfaces, when
performing an operation where the cutting accessory may
contact hidden wiring or its own cord.
Cutting accessory contacting a "dive" wire may make
exposed metal parts of the power tool «live» and could give
the operator an electric shock.
Read these instructions before operating this power tool.
They contain information which will enable you to use the
tool safely and help protect those around you. A copy of this
instruction leaflet should be kept with the tool so that you
can refer to it quickly when undertaking work. Another copy
should be made and safely away. The cut off machine must
be put on the ground to use (Do not equip it on the working
table).
Pay attention to the highest rotational speed limitation
indicated on the cutting wheel do use it according to the
stipulations.
It's limited to use the glass fiber reinforce cutting wheel
with safety linear velocity not less than 8Om/s. It's
forbidden to use any other grinding cutting disk.
Do check if there's any fissure or damage situation of the
cutting wheels before using the machine every time. If
there's such situation, it must be replaced to avoid any
accidents.
Do equip the cutting wheel according to the operation
explanations, use wrench to fix the cutting wheel carefully,
it's possible to occur dangers if equips too loose and it'll
damage the cutting wheel if equips too tight.
Key factors of inspection in trial operation: check the
cutting wheel firstly to confirm its model is conforming to
the requirements of the machine type the cutting wheel is
in good and complete condition. At the time of starting up
the machine, don't touch the materials, to ensure it's
starting up under idling condition. In trial operation, please
keep a little far away from the machine to avoid any
possible accidents.
Please close the current source at once if the cutting wheel
stops, gives noises or vibrates.
The processing project must be clamped tightly, or it's
possibly to occur dangers due to the dithering of the
project: make use of the silk rod handle and plier's plate to
clamp the object tightly, hinge on the base plate and
graduation plate to make processing.
Please note if the machine is equipped in level, the cushion
block can be put under the other end of long project.
Please check the guard apparatus is normal and vice jaw
move the fast nut upward so that the handle can be quickly
pulled out or pushed forward.
Before assembling or disassemble the cutting wheel,
please make sure the machine is switched off or unplugged
in. The linear velocity of all the cutting wheels should be
no less than 8Om/s. The diameter of all cutting wheel
should be no less than 355mm.
Wrench put in the base-wrench, can be removed when
required (picture 1).
A - Self-blocking pin
B - Safe guard
C - Small flange
D - Spanner
When disassemble the cutting wheel, firstly pull up the
movable safety guard and press the self-locking pin to fix
the cutting wheel unscrew the hex bolt counterclockwise
with wrench and then take down the flange and the cutting
wheel. When assemble the cutting wheel, the steps are
opposite to the above-said steps (picture 1, picture 2,
picture 3).
