Idiomas disponibles
Idiomas disponibles
(picture 2)
A - Morable guard
B - Flange
Make sure to tighten the hex bolts. If not fully tightened, it
would lead to injuries. Please use the supplied wrench to
tighten the bolts (picture 3).
A - Cutting blade
B - Flange
C - Small flange
D - Polt
When the cutting wheel is wearing out, it can also be used
economically and efficiently by adjusting the height of
hexagonal bolts to control the cutting angle (picture 4).
A - Ruler sheet
B - Hexagonal bolt
C - Clamp sheet
The fixed distance is between pliers' plate and graduation
plate, if needing wider interspaces, please adjust the
interspaces according to the under mentioned procedures.
Discharge two hexagonal bolts of the fixed graduation
plate, move it like the picture stated, after that, fix the
hexagonal bolt.
According to the adjusting step, it can attain the under
mentioned interspaces setting range (picture 5).
A - Ruler sheet
B - Hexagonal bolt
Release the quick-lock device.
Move the scale plate to the intended cutting angle (0-45°)
and screw the quick-lock device tightly (picture 4). When
the scale plate is set between 35-225 mm or 70-260 mm, it
cannot perform diagonal cutting work. (picture 4)
Turn the handle counterclockwise to lose the movable
effective or not before operating the machine.
After switching on, please wait for the cutting wheel rotates
with full speed, and then begin to cut the project.
Wear gloves and eye protector to avoid rebound and
sustain an injury, don't wear too loose clothes and the
clothes which easy to be reeled and tore. Please take notice
of bundling your hair if with long hair to avoid the danger
that the hair is reeled into the machine.
