Idiomas disponibles
Idiomas disponibles
Be sure you've read and understand the Rope Preparation section on page 14, before continuing.
1
Fully rotate the red tensioner knob in the
counterclockwise (Left) direction, until the rocker arm
bottoms out on the ascenders housing. This will pull
down the tensioner and create space to allow the rope
to feed into the system. Make sure the red knob is
turned fully counterclockwise (Left), until it cannot be
turned any more.
3
Now pull down on the red brake handle slightly and
slowly roll down the thumbwheel, until the rope comes
out the rope exit hole. Do not pull the red brake handle
fully open or this will activate reverse function.
5
Roll down the thumbwheel slowly and run out the slack
in your climbing line until your Ronin is at waste level.
NOTE: You may need to read adjust the tensioner knob to apply
proper tension to the system for climbing/winching as the rope
diameter changes at different points of the rope
Turn knob fully to the left
Turn knob fully to the left
Brake handle
Rope exit hole
ROPE LOADING
2
Insert an approved Static Line Rope (11.5 mm to
13 mm diameter) through the rope inlet hole. Push
until it stops. TAP the thumbwheel once, while pushing
the rope. The system should have pulled in about
2 in (5 cm) of rope.
4
Before Ascending turn the red tensioner knob to the
clockwise (Right) direction, until the upper flange on the
tensioner knob starts to apply tension. Then turn the
knob to the right 6 hand turns, not full revolutions, but
hand turns of the wrist. If you feel the Ronin slipping
on the rope during ascending or winching, then stop
and turn the red tensioner knob clockwise (Right) 1-2
additional turns, until slipping stops. The system is a
no slip system and should never slip, stop immediately
if slippage is felt and adjust the system by turning the
tensioner knob to the right.
RONINPOWERASCENDER.COM
Rope inlet hole
Turn fully to the right until
you start to feel resistance
and then go hand tight.
9
|
