Idiomas disponibles
Idiomas disponibles
• For use in reverse direction the Ronin TL's brake handle must be
tethered fully open (down) by using the Ronin brake latch, a lanyard,
or paracord. If you Ronin TL is not equipped with reverse functionality,
then contact Ronin at [email protected] for upgrade information.
• It is always recommended to have a stop knot at the top of the
rope, when using the remote.
• Do not use the remote if severely damaged in anyway.
• Discontinue use if the thumbwheel does not rotate freely or spring back
to the neutral position, when released.
When winching or hauling with the remote, always use a stop knot at
the end of the rope.
• The wireless remote takes approx. 2 hours to fully charge.
• The charging port on the remote is a standard micro-USB.
• Center LED light will be Green when charging and turn off
when fully charged.
1
Install the battery onto the Ronin TL.
3
Roll down on the remote's
thumbwheel for full variable speed
control. Release the thumbwheel
to stop the Ronin TL's movement.
Roll thumbwheel down
REMOTE PRECAUTIONS
REMOTE CHARGING
REMOTE OPERATION
2
Hold the remotes power button
down for 3 seconds to power on.
The 3 LED's will flash, and the
left LED will be solid Blue, when
paired. Make sure you are within
range of the Ronin TL to pair with
the Ronin TL's receiver.
Note: If the Blue LED is flashing
then it is still attempting to
connect with the Ronin TL.
4
When finished using the remote
you will hold down the power
button for 6 seconds until all
3 LED lights are off.
5
Remove battery from the Ronin TL, when finished
RONINPOWERASCENDER.COM
13
|
