Idiomas disponibles
Idiomas disponibles
EN
English (Original instructions)
FAN
GRECO 16
GRECO 16 ELEGANCE
GRECO 16CR ELEGANCE
GRECO 16CR PURE
DESCRIPTION
A Grille ring
B Nut and screw
C Front grill
D Propeller fastening nut
E Propeller
F Grill fastening nut
G Rear grill
H Motor shaft
I
Motor housing
J Oscillation knob
K Speed buttons
L Desk fan base
M Front grill center cover
N Non-slip feet
O Pole retaining screw (*)
P Adjustable pole (*), (**)
Q Adjustable pole knob (*)
R Lower base pole (*)
S Fan base cover (*)
T Screws for the base (*)
U Round base (*)
(*) Only available in the models GRECO 16CR ELEGANCE
/ GRECO 16CR PURE.
(**) If you do not see this part, ensure it is not located
inside the lower base pole (R) before contacting our
technical service. Remove it carefully to avoid any damage.
If the model of your appliance does not have the
accessories described above, they can also be bought
separately from the Technical Assistance Service.
USE AND CARE
• Fully unroll the appliance's supply cord before each use.
• Do not use the appliance if the on/off switch does not
work.
• Use the appliance handle to catch it or move it.
• Do not use the appliance if it is tipped up and do not turn
it over.
• Do not turn the appliance over while it is in use or
connected to the mains.
• Disconnect the appliance from the mains when not in use
and before undertaking any cleaning task.
• Store this appliance out of reach of children and/or
persons with physical, sensory or reduced mental or lack
of experience and knowledge.
• Make sure that dust, dirt or other foreign objects do not
block the fan grill on the appliance.
• Keep the appliance in good condition. Check that the
moving parts are not misaligned or jammed and make
sure there are no broken parts or anomalies that may
prevent the appliance from operating correctly.
• Never leave the appliance connected and unattended if
is not in use. This saves energy and prolongs the life of
the appliance.
INSTALLATION
• Be sure to remove all packaging material from inside the
appliance.
• Ensure that the fan is switched off from the supply mains
before start any installation or assembly operation.
ASSEMBLING THE BASE (DESK FAN)
• To fix the base into the appliance, place the appliance
face down.
• Fit the base on the main body of the appliance. (Fig. 1).
• Stand the appliance up again so as to check that the base
works properly.
FITTING THE BASE (ROUND BASE STAND FAN)
• The appliance has anti-slip base that support the product.
(U).
• To assemble the base, place the appliance face down.
• Position the base feet on the body of the appliance.
• Position the base on the body of the appliance using the
screws. (Fig. 2).
• Stand the appliance up again so as to check that the base
works properly.
ASSEMBLING THE GRILL AND THE PROPELLER
• Fit the rear grill (G) on the motor housing (I), matching
their fitting points.
• Tight the grill nut (F) that attaches the grill. Make sure of
a correct setting.
• Fit the propeller (E) on the motor shaft (H).
• Tight the nut (D) that attaches the propeller. Make sure of
a correct setting.
• Attach the center cover (M) to the hole on the grill.
