Makita DHR241 Manual De Instrucciones página 7

Torque limiter
The torque limiter will actuate when a certain torque
level is reached. The motor will disengage from the out-
put shaft. When this happens, the bit will stop turning.
CAUTION:
• As soon as the torque limiter actuates, switch off the tool immediately. This will help prevent
premature wear of the tool.
• Hole saws cannot be used with this tool. They
tend to pinch or catch easily in the hole. This
will cause the torque limiter to actuate too
frequently.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
the battery cartridge is removed before carrying
out any work on the tool.
Side grip (auxiliary handle)
1
2
4
3
► 1 . Grip base 2. Side grip 3. Loosen 4. Tighten
5. Teeth 6. Protrusion
CAUTION:
• Always use the side grip to ensure operating
safety.
Install the side grip so that the teeth on the grip fit in
between the protrusions on the tool barrel. Then tighten
the grip by turning clockwise at the desired position. It
may be swung 360° so as to be secured at any position.
Bit grease
Coat the bit shank head beforehand with a small
amount of bit grease (about 0.5 -1 g; 0.02 - 0.04 oz.).
This chuck lubrication assures smooth action and lon-
ger service life.
5 6
Installing or removing the bit
Clean the bit shank and apply bit grease before install-
ing the bit.
1
► 1 . Bit shank 2. Bit grease
Insert the bit into the tool. Turn the bit and push it in until
it engages.
1
► 1 . Bit 2. Chuck cover
If the bit cannot be pushed in, remove the bit. Pull the
chuck cover down a couple of times. Then insert the bit
again. Turn the bit and push it in until it engages.
After installing, always make sure that the bit is securely
held in place by trying to pull it out.
To remove the bit, pull the chuck cover down all the way
and pull the bit out.
1
► 1 . Bit 2. Chuck cover
7 ENGLISH
2
2
2