cecotec ENERGYSILENCE AERO 5200 LIGHT WHITEWOOD Manual De Instrucciones página 41

- If you notice that the transmitter does not control the receiver, check that the batteries
are inserted correctly and that they are not dead.
- This may also be due to the proximity of similar products that also operate with a remote
control, which, if they use the same frequency, could cause interference.
- If the batteries in the remote control are dead, replace them so that you can continue to
use it normally.
- Remove the batteries from the remote control if you are not going to use it for a long
period of time.
- Make sure that the earth wire is properly connected.
- When positioning the fan, make sure that no wires are pinched. If this happens, a short-
circuit may occur.
Reminder
- The receiver must be correctly installed in the fan mounting bracket.
- Remove the batteries from the remote control if you are not going to use it for a long
period of time.
- The isolation switch must be switched on.
- If the power is cut off (e.g. due to a blackout) the light will go out. When the power is
restored, the light will switch on again.
Receiver protection functions
- The DC motor has a built-in safety feature against blade or motor obstruction during
operation.
- During operation, if any object obstructs the fan blades or motor, the motor will attempt
to run for 30 seconds and then stop operating. Remove obstructions and restart the
motor. To restart it: Switch the fan off from the remote control and then switch it on
again.
- The device will limit the maximum current output from the receiver/drive if the fan load
has increased abnormally.
Tips
- If the fan or light does not work, reset the fan. To do this, turn it off for at least 5 seconds
and then turn it on again. Then, reset the learning code matching mode setting.
- It is not possible to control more than one fan in the same room if they share the same
power supply.
- If you want to separately control more than one fan in the same room, you must use
separate power supplies.
- When the fan is switched on and starts running in either direction (clockwise or
counterclockwise), it will stop and change direction several times. This is normal. The fan
will take some time to perform the selected function and to start up regularly.
ENERGYSILENCE AERO 5200 LIGHT WHITEWOOD / BLACKWOOD
ENGLISH
41