Epson UB-U06 Manual De Usuario página 3

Procedure
If a UB-BOARD is currently installed in your printer, you need to remove it first before you install the
new UB-U06 board. Disconnect the power supply from the printer and follow the steps below.
1. Removing the current UB-BOARD from the printer
Remove the two screws that secure the UB-BOARD; then pull the UB-BOARD to remove it. You
will use the screws when installing the UB-U06.
CAUTION:
Put the UB-BOARD into an anti-static bag for storage to prevent damage from static electricity.
2. Installing the UB-U06 enclosed in the package
Hold the UB-U06 as shown in the illustration below. Push the UB-U06 in gently until you feel the
connector fit into the place.
Connector of the UB-U06
3. Setting the UB-U06
Secure the UB-U06 with the two screws.
4. Setting the printer settings
Change the printer settings following the printer manual.
5. Installing the USB Plus Power cable
Connect the rectangle-shaped side of the connector of the USB Plus Power cable to the UB-U06
USB Plus Power up-stream connector. Connect the square-shaped side of the connector of the
USB Plus Power cable to the down-stream connector of the host computer.
CAUTION:
Be sure not to use any cable not specified for the USB Plus Power. An improper cable can damage the
UB-U06 and cause an electric shock.
6. Installing the Software
Install the device driver for the UB-U06. Please ask your dealer how to install it.
Connector of the TM printer
USB Plus Power up-stream connector
3