Miele Triflex HX1 Serie Instrucciones De Funcionamiento página 123

Inserting the battery (Fig. 07)
 Push the battery along the guide lines
until it audibly clicks into place in the
PowerUnit.
 If you want to separate the sections
again, press both release catches at
the side of the battery to remove the
battery (Fig. 08).
Connecting the Electrobrush (Fig. 09)
Depending on how you decide to con-
figure your vacuum cleaner, you can
connect either the PowerUnit connector
or the suction wand connector to the
Electrobrush.
 Insert the connector down into the
Electrobrush from above until it audi-
bly clicks into place.
 To separate the individual sections
from each other, press the release
catch on the Electrobrush and pull the
connector out of the Electrobrush
(Fig. 10).
General battery information
The rechargeable battery is supplied not
fully charged.
Charge the battery completely before
using it for the first time. Allow approxi-
mately 4 hours for this.
To activate the battery, it is essential to
place it in the PowerUnit when charging
it for the first time.
Once the battery is fully charged, the
battery charging state indicator on the
PowerUnit switches off to conserve en-
ergy.
The maximum charging capacity is
only achieved once the battery has
been charged and run down five times.
A full charge provides enough power for
17 minutes if the vacuum cleaner is used
at the maximum power level in its fully
assembled state.
However, if you use the PowerUnit solo
and select the minimum power level,
you can vacuum for up to 60 minutes at
a time.
Charging the battery (without wall
mounting) (Fig. 11)
You can store the vacuum cleaner up-
right and charge the battery directly.
Before charging the battery for the first
time, you must read the information in
"Installation and connection" – "Gen-
eral battery information".
 Connect the PowerUnit to the Elec-
trobrush to provide a secure base for
the vacuum cleaner.
 Swing the vacuum cleaner forward
until the Electrobrush connector audi-
bly clicks into place.
 Plug the supplied charging cable into
the charging socket on the bottom of
the battery.
 Plug the charger into a power socket.
The charging process will start.
You can read more about this in "Bat-
tery charging state indicator (while
charging)".
Charging the battery (with wall mount-
ing) (Fig. 12)
There are 2 ways to store and charge
the vacuum cleaner in the supplied wall
bracket.
en-US
123