Idiomas disponibles
Idiomas disponibles
ENGLISH
Installing the blades
1.
Remove the motor screws as shown in Fig. 7.
Then, remove the blades from the box and check that their holes match those of the
2.
motor as shown in Fig. 8.
Installing the LED light
1.
Remove the screws from the motor light, Fig. 9.
Afterwards, take out the LED light from the box, align its holes with the holes of the motor
2.
as shown in figure 10 and tighten the screws.
Connecting the lighting wires
Connect the phase wire to the light wire using the terminal located in the mounting kit
1.
bag. Then connect the neutral wire of the fan to the neutral wire of the light, also with a
terminal as shown in Fig. 11.
Fig. 11 key
Phase wire
1.
Neutral wire
2.
NOTE: when the wires are connected, use the heat shrink sleeve (found in the mounting kit bag)
to join the two terminals together. Shrink the sleeve with the help of a heat gun.
Once you have connected the light wires, insert the two terminals into the hole in the
2.
lamp panel as shown in Fig. 12.
Installing the lampshade
Fig. 13
Take out the lampshade from the box. Fit the three tabs of the lampshade with the slots
1.
of the LED light panel.
2.
Next, turn the lampshade clockwise.
Power cord connection
Fig. 14
NOTE: the wiring must be disconnected from the power supply. It must be connected to a plug
with a minimum spacing of 3 millimetres per pole.
The wall switch can be used to turn the light on or off. The remote control can also be used to
switch the light on and off and to adjust the speed.
Installation
-
Connect the blue wire from the remote-control receiver to the blue wire from the fan.
46
ENERGYSILENCE 4800 LIGHT WHITE/BLACK/GOLDWHITE/GOLDBLACK
