Idiomas disponibles
Idiomas disponibles
INSTRUCTIONS FOR USE
Functions of the control panel (Fig. 2)
A
Power on/off
B
Fan speed
C
Humidity up / Timer up
D
Humidity down / Timer down
E
Operation modes
F
Timer on/off
Humidity level and timer digital display
1. After turning on the dehumidifier, the digital display will show the
indoor % of humidity.
2. It will indicate the selected humidity when you set the desired % of
humidity.
3. If you program the timer for the dehumidifier, it will show the hours
of working.
4. When the environment humidity is lower than 35%, it will show "LO".
5. When the environment humidity is higher than 95%, it will show "HI".
How to use
1. Plug in the unit.
2. Press the power on/off button to start operation, the power indicator will be on. Press
it again to stop operation.
3. Select the fan speed button to select the wind speed.
4. Set the humidity up or the humidity down buttons to set the desired % of humidity
level in the room, which can be set from 30% to 90% at 5% intervals or to "CO". When
setting the humidity to "CO", the compressor will run continuously.
5. After 10 seconds from the humidity setting is selected, the digital display shows the
ambient humidity.
6. After a period of working, when environment humidity is lower than the selected hu-
midity by 2%, the compressor will stop.
7. When the environment humidity is equal to or higher than the selected humidity by
3%, compressor will restart once the 3 minutes of compressor protection time is over.
Operation modes
Press the operation mode button to switch between silence, dehumidifying or dryer
mode.
- Silence mode: Runs the dehumidifier at a low wind speed. The wind speed cannot be
adjusted.
G
Silence mode
H
Dehumidifying mode
I
Dryer mode
J
Water full alarm
K
High fan speed
L
Low fan speed
33
