Idiomas disponibles
Idiomas disponibles
Ring
CAUTION:
Before using the ring, always
make sure that the bracket and ring are secured
and not damaged.
CAUTION:
Use the hanging/mounting parts
for their intended purposes only. Using for unin-
tended purpose may cause accident or personal
injury.
The ring is convenient for hanging the tool with hoist.
First, place the rope through the ring. Then hang the
tool up to the air with hoist.
If you want to remove the ring, ask your local Makita
Service Center.
► Fig.11: 1. Bracket 2. Ring 3. Screws
OPERATION
CAUTION:
When using the tool in high
places, make sure that no one is below you.
Dropping your tool from a height may cause serious
injuries.
CAUTION:
If the tool malfunctions or makes
abnormal noises, stop using the tool. then contact
your local Makita Service Center.
Angle and position adjustment of
the side handle
CAUTION:
Always use the side handle to
ensure safe operation.
CAUTION:
After installing or adjusting the
side handle, make sure that the side handle is
firmly secured.
The angle of the side handle can be adjusted at 9 steps
back and forth in a horizontal direction. The position of
the side handle can also be adjusted 360° every 45°
around the circumference of the hammer case.
Angle adjustment of the side handle
1.
Loosen the clamp nut.
2.
Adjust the angle of the side handle back and forth
to the desired angle as shown in the figure.
3.
Tighten the clamp nut firmly.
► Fig.12: 1. Side handle 2. Clamp nut
Position adjustment of the side
handle
1.
Loosen the clamp nut.
2.
Adjust the position of the side handle to the
desired position by rotating the side handle to the
left or right as shown in the figure.
3.
Tighten the clamp nut firmly.
► Fig.13: 1. Side handle 2. Clamp nut
Tightening bolt
CAUTION:
Hold the tool securely to prevent
your body from being swung around by the tool
when using the tool.
CAUTION:
Always insert the battery cartridge
all the way until it locks in place. If you can see the
red indicator, it is not locked completely. Insert it fully
until the red indicator cannot be seen. If not, it may
accidentally fall out of the tool, causing injury to you
or someone around you.
Hold the tool firmly and place the impact socket over
the bolt or nut. Turn the tool on and fasten for the proper
fastening time.
► Fig.14
The proper fastening torque may differ depending upon
the kind or size of the bolt, the material of the workpiece
to be fastened, etc. The relation between fastening
torque and fastening time is shown in the figures.
Proper fastening torque for high tensile bolt with
max impact mode (4)
N•m
(kgf•cm)
3000
(30591)
2500
(25492)
2000
(20394)
2
2
1500
(15295)
1000
(10197)
500
(5098)
0
1. Fastening time (second) 2. Fastening torque
NOTE: Hold the tool pointed straight at the bolt or nut.
NOTE: Excessive fastening torque may damage the
bolt/nut or impact socket. Before starting your job,
always perform a test operation to determine the
proper fastening time for your bolt or nut.
NOTE: If the tool is operated continuously until the
battery cartridge has discharged, allow the tool to rest
for 15 minutes before proceeding with a fresh battery
cartridge.
12 ENGLISH
M33
M30
M27
1
2
3
1
M33
M30
M27
