Makita TW009G Manual De Instrucciones página 10

Application mode
(Impact force grade
displayed on panel)
2 (Medium)
1 (Soft)
: The lamp is on.
NOTE: When none of the lamps on the switch panel is lit, pull the switch trigger once before pressing the but-
ton .
NOTE: All lamps on the switch panel go out when the tool is turned off to save the battery power. The impact force
grade can be checked by pulling the switch trigger to the extent that the tool does not operate.
Changing the application mode
This tool employs several easy-to-use application modes for driving bolts with good control.
The type of the application mode changes every time you press the button
You can change the application mode within approximately one minute after releasing the switch trigger.
NOTE: You can extend the time to change the application mode approximately one minute if you press the but-
ton or .
► Fig.8: 1. Button
Application mode
(Assist type displayed on panel)
Bolt mode
Bolt mode (1)
Maximum blows
TW009G TW010G
-1
1,300 min (/min)
-1
1,200 min (/min)
Purpose
Tightening when a good finishing is
needed.
Tightening when you need good control
power.
Tightening with less force to avoid screw
thread breakage.
Tightening when you need fine adjust-
ment with small diameter bolts.
.
Feature
Clockwise
This mode helps to repeat
screwdriving continuously
with equal torque. This mode
also helps to reduce the risk of
breakage of bolts/nuts due to
overtightening.
Counterclockwise
This mode helps to prevent a
bolt from falling off. When loos-
ening a bolt with the tool driving
in counterclockwise rotation,
the tool automatically stops or
slows down after the bolt/nut
gets enough loosened.
NOTE:
The timing to stop the driving
varies depending on the type
of the bolt/nut and material to
be driven. Make a test driving
before using this mode.
Clockwise
The impact force is 2. The tool
stops automatically as soon as
it has started impact blows.
Counterclockwise
The impact force is 4. The tool
stops automatically as soon as
it has stopped impact blows.
10 ENGLISH
Purpose
Clockwise
Preventing overtightening of
bolts.
Counterclockwise
Loosening bolts.
–