prevent the fan from falling. Loosen the two canopy screws from the mounting bracket.
Note: self-tapping screws are only suitable for wooden ceilings. In case of installing the ceiling
fan to concrete ceilings or joists, use a drill for making the holes and stoppers or expansion
bolts (not included).
5. Loosen the hanging ball screws until the ball slides down the downrod. Remove the
downrod pin. Fig. 7
Fig. 7 key:
1.
Hanging ball
2. Pin
3. Screw
1.
Remove the pin and the pin clip from the downrod. Slide the downrod through the canopy
and the downrod cover. Fig. 8
2. Loosen the screws of the mounting bracket and then place the downrod in the mounting
bracket. Route the fan wires and the earth wire through the downrod as shown in Figure
9. Align the holes in the clevis pin of the downrod with the holes in the bracket. Make sure
to insert the straight part of the clevis pin through the hole in the end of the clevis pin and
press until the crimped part snaps into position. Finally, retighten the screws.
Warning: it is very important that the downrod bracket pin is correctly installed and that the
screws are tightened securely.
If the pin, clevis, or screws are not correctly positioned, the fan may fall down.
3. Hang the fan on the mounting bracket. Fig. 10
4. Fix the lamp bracket to the motor with 3 screws and then fix the lampshade with 4 screws.
Fig. 11
Note: when installation is complete, check all parts.
Please note: before fitting the bulb, make sure that the fan is not connected to the mains.
5. Connections: connect the main power supply (house) to the terminal block located on the
mounting bracket. Plug the receiver into the mounting bracket with the flat side up. Fig. 12
-
Insert the 3P connector of the mounting bracket into the AC POWER INPUT socket of the
receiver.
-
Insert the 2P light connector from the fan motor assembly into the 2P LIGHT socket on the
receiver.
-
Insert the 3P connector of the fan motor into the 3P MOTOR socket of the receiver.
ENERGYSILENCE AERO 3600 INVISIBLE NATURAL STYLE
ENGLISH
47