Getting Started; Canceling The Display Demonstration; Setting The Demonstration Mode; Adjusting The Clock - Kenwood KDC-MP102U Manual De Instrucciones

Getting started

Canceling the display
demonstration
The display demonstration is always turned
on unless you cancel it.
When you turn on the power (or after you
reset the unit), the display shows:
[CANCEL] \ [DEMO] \ [PRESS] \
[VOLUME] \ [KNOB]
1 Press the volume knob.
[ <Y>/ N ] is selected as the initial setup.
2 Press the volume knob again to confirm.
[DEMO OFF] appears.
If no operation is done for about 15 seconds
or if you turn the volume knob to select
[ Y /<N> ] in step 2, [DEMOMODE] appears
and the display demonstration starts.

Setting the demonstration mode

1 Press the volume knob to enter
[FUNCTION] mode.
2 Turn the volume knob to select [DEMO],
then press to enter.
3 Turn the volume knob to select
[DEMO ON] or [DEMO OFF].
If [DEMO ON] is selected, display
demonstration starts if no operation is
done for about 20 seconds.
4 Hold to finish the procedure.
Item
PRESET TYPE NML *: Memorizes one station for each preset button in each band (FM1/ FM2/ FM3/ AM). ;
TYPE MIX: Memorizes one station for each preset button regardless of the selected band (FM1/ FM2/ FM3/ AM).
KEY BEEP BEEP ON */ BEEP OFF: Activates/deactivates the keypress tone.
AUX SET AUX ON *: Enables "AUX" in source selection. Sound of the connected external component is produce through the
car speakers. ; AUX OFF: Disables "AUX" in source selection.
CD READ CD READ1 *: Automatically distinguishes between audio file disc and music CD. ; CD READ2: Forces to play as a
music CD. No sound can be heard if an audio file disc is played.
SWPRE SWPRE R */ SWPRE SW: Selects whether rear speakers or a subwoofer are connected to the line out terminals on
the rear of the unit (through an external amplifier).
SPEAKER SP OFF */ SP 5/4/ SP 6×9/6/ SP OEM: Selects the speaker size for optimum performance.
F/W xx.xx <Y>/ N *: Starts upgrading the firmware. ; Y /<N>: Cancels (upgrading is not activated).
For details on how to update the firmware, see: www.kenwood.com/cs/ce/
6

Adjusting the clock

1 Press the volume knob to enter
[FUNCTION] mode.
2 Turn the volume knob to select
[SETTINGS], then press to enter.
3 Turn the volume knob to select [CLOCK],
then press to enter.
4 Press the volume knob to select
[CLK ADJ].
Clock hour flashes on the display.
5 Turn the volume knob to adjust the hour,
then press to enter minute adjustment.
Clock minutes flashes on the display.
6 Turn the volume knob to adjust the
minute, then press to confirm.
Press 4 / ¢ to move between the
hour and minute adjustment.
7 Hold

Initial settings before operations

1 Press
2 Press the volume knob to enter
[FUNCTION] mode.
3 Turn the volume knob to select
[INITIAL], then press to enter.
4 Turn the volume knob to make a
selection, then press to confirm.
See table below for selection.
5 Hold
Selectable setting (Preset: *)
to finish the procedure.
SRC to enter [STANDBY] mode.
to finish the procedure.