Idiomas disponibles
Idiomas disponibles
◾
Stop the motor and remove the battery pack
whenever you leave the tool.
◾
Store idle appliances indoors. When not in use,
appliances should be stored indoors in a dry and high
or locked-up place with the battery pack removed, out
of reach of children.
◾
Check damaged parts. Before further use of the
product, a guard or other part that is damaged should
be carefully checked to determine that it will operate
properly and perform its intended function. Check for
alignment of moving parts, binding of moving parts,
breakage of parts, mounting, and any other condition
that may affect its operation. A guard or other part that
is damaged should be properly repaired or replaced
by an authorized service center unless indicated
elsewhere in this manual.
ADDITIONAL SAFETY INSTRUCTIONS FOR
EXTENDED-POLE SAW
◾
Do not charge the battery pack in rain, or in wet
locations.
◾
The battery pack must be removed from the
appliance before it is scrapped.
◾
The battery shall be disposed of safely.
◾
Do not dispose of the battery in a fire. The cells may
explode. Check with local codes for possible special
disposal instructions.
◾
Do not open or mutilate the battery. Released
electrolyte is corrosive and may cause damage to the
eyes or skin. It may be toxic if swallowed.
CAUTION! The electrolyte is a dilute sulfuric acid
that is harmful to the skin and eyes. It is electrically
conductive and corrosive.
◾
Exercise care in handling batteries in order not
to short the battery with conducting materials
such as rings, bracelets, and keys. The battery or
conductor may overheat and cause burns.
◾
Battery tools do not have to be plugged into an
electrical outlet; therefore, they are always in
operating condition. Be aware of possible hazards
even when the tool is not operating. Take care when
performing maintenance or service.
◾
Remove the battery pack before servicing, cleaning
or removing material from the tool.
◾
Replacement parts - When servicing, use only
identical EGO replacement parts. Use of any other
accessory or attachment may increase the risk of injury.
◾
Do not wash with a hose; avoid getting water in
motor and electrical connections.
◾
If situations occur that are not covered in this
manual, use care and good judgment. Contact the
EGO Service Center for assistance.
◾
Save these instructions. Refer to them frequently and
use them to instruct others who may use this tool.
◾
If you lend this tool to someone else, also lend these
instructions to them to prevent misuse of the product
and possible injury.
◾
Use only with the battery packs and chargers listed
in Fig.A2.
SAVE THESE INSTRUCTIONS
NOTE: SEE YOUR POWER POLE OPERATOR'S
MANUAL FOR ADDITIONAL SPECIFIC SAFETY RULES.
SPECIFICATIONS
Guide Bar Length
Chain Pitch
Chain Gauge
Saw Chain Type
Guide Bar Type
Chain Oil Tank Capacity
Recommended Operating
Temperature
Recommended Storage Temperature -20°C-70°C
Weight (with chain sheath)
Measured sound power level L
Sound pressure level at operator's
ear L
PA
Guaranteed sound power level L
(measured according to 2000/14/EC)
Front handle
Valuation of
vibration a
:
h
Rear handle
◾
The above parameters are tested and measured
equipped with power pole PPX1000.
◾
The declared vibration total value has been measured
in accordance with a standard test method and may be
used for comparing one tool with another;
◾
The declared vibration total value may also be used in
a preliminary assessment of exposure.
POLE SAW ATTACHMENT — PSX2500
EN
250 mm
3/8"(9.5 mm)
1.1 mm
AC1000/AC1001
AG1000/AG1001
150 ml
-10°C-40°C
2.0 kg
98.54 dB(A)
K=2.3 dB(A)
WA
85 dB(A)
K=2.5 dB(A)
101 dB(A)
WA
1.2 m/s
2
K=1.5 m/s
2
1.2 m/s
2
K=1.5 m/s
2
7
