Idiomas disponibles
Idiomas disponibles
25
7. Choice of location
Before putting the device into operation, the following points must be observed: The device
must be used indoors.
ATTENTION! Never use the device in vehicles/trailers.
Fire! - ATTENTION! The use of extension cables, multiple plugs or timers (= timers) is not
permitted.
Fire! - Put the device into operation only on a stable surface and only in an upright position.
Make sure that the device has good stability and no one can trip over the device or power
cord.
ATTENTION! The device or parts of it become very hot during operation.
Make sure that it is not in the immediate vicinity of flammable/heat-sensitive objects (e.g.
curtains, furniture, candles, etc.).
Fire! Obtained a minimum distance of 2 m. This is especially true at the front. The device
complies with protection class "I" and may only be connected to a grounded socket. Do not
place the device in front of or under the socket. The power plug must be able to be
unplugged at any time. We recommend connecting the device via a 30 mAFI protector. In
case of doubt, ask a specialist,
8. Connect the commissioning device to the mains
The device is ready for operation by plugging in the mains plug (220-230 V).
WARNING! The power cord must not touch the device.
Fire-/Stromschloggefohr! Turn on/off device with the power button
(13) on the back (= «I»); a beep sounds and the device is in the Stondby. When not in use,
always turn off (= «0») and unplug it. Manual operation on the device The basic functions can
be set directly on the device.
The keys (6) are located directly at the power button on the back. Adjust the heating (on the
appliance) By repeatedly pressing (8), turn on the heating function and select the heating
power: Maximum power («1900 W»): lights up red - Deep power («950 W»): lights up blue off:
does not light up -
Note: When the manual device is switched on, the heating elements work but are not
controlled by the temperature sensor.
Set flame effect (on device)
By repeatedly pressing the «flame function» and select its height: Maximum flame
brightness/height Average flame brightness/height - Depth flame brightness/height - Flames
switched off Operation with remote control.
With the remote control (14), additional functions can be operated in addition to the basic
functions. The remote control only works if the power button (13) on the back of the device is
switched on and the remote control is directed at the device (maximum distance 6 m).
By pressing a toast, the remote control indicator turns on. Turn on the device (from Stondby) -
Point the remote control at the device. - Turn on by pressing device. The flame and ember
effect is switched on. The heating is switched off.
Turn off the device by pressing it again. Ember/Flommen Effect - Direct remote control to
device. By repeatedly pressing the flame and ember effect. The effect can also be switched
on for decoration without a heating function. - Adjust the gluthelity.
Adjust heating (with remote control)
Point the remote control at the device. Turn on by pressing the heater: the heater starts with
maximum power (1900 W, in the display appears
<<□□)), the device lights up red). - Change heating power: - press during one second to
reduce the power to 950 W (in the display appears
www.eshopping.de
Hergestellt für Dilaw Warehouse GmbH // Fuggerstraße 15a // 48165 Münster // Germany
