How To Attach - Leckey Horizon Manual Del Usuario

7.5 How to attach the
headsupport & extended
headrest bracket in Supine
To attach and height adjust, slide the
square tubing into the top of the central
spine on the backrest. To lock the head
support push the locking lever down until
it touches the metal spine (b). To remove
simply reverse this process. The extended
headrest, the contoured head support
and the Whitmyer Pro-Series range of
headsupports can also be attached to the
frame as detailed above.
After use locking lever may need to be fine
tuned to ensure secure locking. To do this
lift up the lever and turn the nut (c) while
holding the lever in a fixed position. Push
the lever back down to check if it locks
the tube securely. Repeat the process as
necessary.
Always use caution when making
this adjustment, as fingers could
become trapped in the receiving tube
while positioning.
C
7.6 How to attach the
headsupport in prone
If headsupport is needed in prone standing
the Leckey Interface Frame (LIF) can be
used with Horizon Stander. The LIF is
attached to and removed from the frame by
the metal brackets located below the chest
pad. To attach, slide the metal bars into the
receiving tubes to the required depth
and secure by tightening the knobs on
either side.
Please refer to the specific user manual
on the Leckey Interface Frame to safely
position the frame and its accessories.
This frame will also accommodate
the Whitmyer pro-series range of
headsupports.
B

7.7 How to attach

Flexible Guides
To attach the flexible guides, loosen the
plastic knob (a) at the back of the pad and
slide the metal bracket into the slot. Then
when set to the desired height retighten the
plastic knob. Repeat on the other side.
A
7.8 How to attach and
remove basic / flip-away /
3D footplates
To remove the footplate loosen the bolts
which attach the footplate to the bottom of
the spine (a). Slide the footplate downwards
and remove.
To attach a footplate, loosen the bolts at
either side of the footplate (a) and slide
upwards on to spine. Ensure the slider
plate is firmly inserted into groove in spine.
Tighten the bolts once the footplate is in
the required position.
A