Idiomas disponibles
Idiomas disponibles
REMOTE CONTROL
* Direct the infrared light-emitter of remote control towards the receiver of the front of the remote control .
Power button
Press the button to start operation .
Press the button again to turn off
the power and stop operation .
Oscillation button
Adjust the oscillation setting .
Mode button
Adjust the mode setting .
Battery protection sheet
Unplug before use .
How to replace the battery.
If the operating radius becomes reduced, or nothing happens when pressing
the power button, replace the battery with a new one (CR2025) .
1. Pull out the battery holder.
• Press the claw in the direction of the arrow and pull out the battery holder.
2. Insert the new battery.
• Insert the new battery into the battery holder in the right direction and
insert it into the Remote control.
* Do not confuse the positive and negative polarities of the battery .
* Dispose the used battery as described in the battery package or in
accordance with local regulations .
Precautions for battery.
• Pay attention to the polarity(plus ⊕ and minus ⊖ ) and insert the
battery correctly according to the instructions.
Failure to do so may cause fire, injury, or deface the surrounding
environment due to battery breaking or liquid leakage .
• Remove the battery if it is not used for a long time.
Failure to do so may cause fire, injury or deface the surrounding area due to
liquid leakage .
In case of liquid leakage, wipe the liquid off the battery holder and replace with a new
one . If you come in contact with the leaked fluid, wash out thoroughly with water .
• Do not disassemble.
Attempting to disassemble may harm your skin and clothing .
• Do not carry or store with any objects made of metals.
Carrying or storing with objects made of metal may cause liquid leakage or
explosion due to short circuit .
• Do not use non-designated batteries.
Using non-designated batteries may cause fire, injury, or deface the
surrounding area due to battery breaking or liquid leakage .
• Do not charge coin batteries.
Attempting to charge coin batteries may cause fire, injury or burn due to
battery breaking or liquid leakage .
Infrared light-emitter
Speed button
Every time the speed button is pressed, the speed
will switch as following :
Weak wind
01 （ ） → 02 → 03 → ・ ・ ・ → 10 → 11 → 12 （ ）
Timer button
Adjust the timer setting .
Claw
①
Hold to pull out
6
Strong wind
Back
②
Battery holder
Above
Image from
the side
