Craftsman 315.111720 Manual Del Propietário página 7

OPERATION
TO INSTALL BATTERY PACK
Lock switch trigger on your drill by placing the direction
of rotation selector in center position. See Figure 2.
lli Orient batter,] pack so that terminals on battery pack
align with terminals in drill housing, insert battery pack
in driIlo See Figure 3,
m Make sure the latches on each side of your battery
pack snap in place and battery pack is secured in drill
before beginning operation_
TO REMOVE BATTERY PACK
[] Lock switch trigger on your drill by placing the direction
of rotation selector in center position. See Figure 2.
Locate latches on end of battery pack and depress to
release and remove battery pack, See Figure 3.
CAUTION:
When placing battery pack in your drill, be sure battery
p_ck terminals align with drillterminals and latches snap
in place properly. Improper assembly of battery packcan
cause damage to internal components.
WRIST STRAP
See Figures 1 and 3o
A wrist strap is provided to reduce the chances of dropping
your drillo Place one hand through the wrist strap when
carrying tool.
SWITCH
See Figure 2,
To turn your drill ON, depress the switch trigger_ To turn it
OFF, release the switch trigger. The switch of this drill has
been designed for two speed drilling. For low speed drilling,
depress the switch trigger halfway_ For normal ddlling,
depress the switch trigger all the way,
NOTE: When changing from low to high speed, you may
notice a dead spot in the trigger switch. This is part of the
design of the switch and there is nothing wrong with your
drill. Continue to pull the switch trigger until high speed
drilling begins.
SWITCH LOCK
See Figure 2.
The switch trigger can be locked in OFF position ,This feature
can be used to prevent the possibility of accidental starting
when nQt in use, To lock switch trigger, place the direction
of rotation selector in the center position,
REVERSE
Fig. 2
FORWARD
SELECTOR
BATTERY 1 l_
PACK
CENTER
POSITION
(LOCK-OFF)
DEPRESS LATCHESTO
RELEASEBATTERY PACK
WRISTSTRAP
LATCHES
Fig. 3
CAUTION:
To prevent gear damage, always allow chuck to come to
a complete stop before changing the direction of rotation°
See Figure 2
This tool has the feature of being reversibleo The direction
of rotation is controlled by a selector located above the
switch trigger. With the drill held in normal operation posi-
tion, the direction of rotation selector should be positioned
to the left of the switch for drilling. The driiting direction is
reversed when the selector is to the right of the switch.
When the selector is in center position, the switch
trigger is locked.
To stop, release switch trigger and allow the chuck to come
to a complete stop.
WARNING:
Battery tools are aIways in operating condition..Therefore,
switch should always be locked when not in use or
carrying at your side°
Page 7