Idiomas disponibles
Idiomas disponibles
6
STEP 6: Install the rear fender
a. Use a 10 mm open-end wrench to loosen the fender bolt nut on the
seat tube joint, and then remove the bolt and nut.
b. After aligning the fender with the screw hole, retighten the mounting
screws to affix it onto the seat tube joint, as shown in Figure 6-1.
c. After confirming that the front fender is aligned with the screw hole,
use a 5 mm Allen key to push the bolt and a 10 mm open-end wrench
to retighten the nut on the other side to the torque of 4-6 N·m. Don't
forget the spacers.
d. After fastening the upper bracket, use a 4 mm Allen key to remove the
2 screws at the dropout. Then, align the legs of the front fender with the
installation holes, as shown in Figures 6-2 and 6-3, and then re-tighten
the screws.
Figure 5-1
Figure 5-2
Figure 5-3
STEP 7: Connect the Cable
Turn your bike up side down.
a. Loosen the four screws on the cover next to the bottom bracket in a
counterclockwise direction with a 3 mm Allen key, then remove the
screws and the cover, as shown in Figure 7-1.
b. Connect the cable between the battery and the controller, as shown
in Figure 7-2.
c. Put the cover back and re-tighten the screws.
Figure 6-1
Figure 6-2
Figure 6-3
Figure 7-1
8-10扳手
13-15扳手
17-19扳手
8字过线卡
